JVC LVT1007-010A[A] manual Connecting the Speakers, Open the speaker terminal, Speaker layout

Connecting the Speakers

You can connect the following speakers:

•Two pairs of front speakers to produce normal stereo sound.

•One pair of surround speakers to enjoy the surround effect.

•One surround back speaker or one pair of surround back speakers to enjoy to produce more effective surround effect.

•One center speaker to emphasize human voices.

•One subwoofer to enhance the bass.

CAUTION:

Use only the speakers of the SPEAKER IMPEDANCE indicated by the speaker terminals.

•When connecting to both of the FRONT SPEAKERS 1 and 2 terminals, use speakers with an impedance of 16 Ω to 32 Ω.

•When connecting to either the FRONT SPEAKERS 1 or 2 terminals, use speakers with an impedance of 8 Ω to 16 Ω.

Basic connecting procedure

1 Twist and remove the insulation at the end of each speaker signal cable (not supplied).

2 Open the speaker terminal.

+ –

RIGHT

LEFT	LEFT
	RIGHT

For FRONT SPEAKERS 2 terminals

3 Insert the speaker signal cable.

Speaker layout

Ideal speaker layout varies depending on the conditions of your listening room. The diagram below is a recommended typical example.

Subwoofer

Left front speaker(s)	Center speaker	Right front speaker(s)
(L)	(C)	(R)

Left surround	Right surround
speaker (LS)	speaker (RS)

Surround back speakers (LSB/RSB)

RIGHT

LEFT

4 Close the speaker terminal.

RIGHT

LEFT

+ –

LEFT

RIGHT

+ –

LEFT

RIGHT

For each speaker (except for a subwoofer), connect the (+) and (–) terminals on the rear panel to the (+) and (–) terminals marked on the speakers.

9