JVC LVT1007-010A[A] manual Video component connections, TV and/or DBS tuner

Video component connections

Use the cables with RCA pin plugs (not supplied).

Connect the white plug to the audio left jack, the red plug to the audio right jack, and the yellow plug to the video jack.

•If your video components have S-video (Y/C-separation) and/or component video (Y, PB, PR) terminals, connect them using an S- video cable (not supplied) and/or component video cable (not supplied). By using these jacks, you can get better picture quality in the order—Component video > S-video > Composite video.

If your video components have an AV COMPULINK jack

See also page 40 for detailed information about the connection and the AV COMPU LINK remote control system.

IMPORTANT:

This receiver is equipped with the following video jacks—composite video, S-video and component video jacks. You can use any of the three to connect a video component.

However, the video signals from one type of these input jacks are transmitted only through the video output jacks of the same type.

Therefore, if a recording video component and a playing video component are connected to the receiver through the video jacks of different type, you cannot record the picture. In addition, if the TV and a playing video component are connected to the receiver through the video jacks of different type, you cannot view the playback picture on the TV.

TV and/or DBS tuner

To listen to the sound after connection, press TV SOUND/DBS (or TV/DBS on the remote control).

MONITOR
OUT
Y	PB	PR
R	TV SOUND
A	DBS
	IN
L
TV
When “TV” has	MONITOR
	OUT
been assingned as
the source name
(see page 19), no
signal comes out of
these terminals.

B

C

D

Connect the TV to appropriate MONITOR OUT jacks to view the playback picture from any other connected video components.

VCR

To listen to the sound after connection, press VCR.

Å To audio input ı To audio output Ç To S-video output

Î To composite video output

‰To S-video input

ÏTo composite video input

A B	C D E F
	VCR

ÅTo audio output

ıTo component video input Ç To S-video input

ÎTo composite video input

DBS

IN

R

ATV SOUND

DBS

L

IN

R	OUT
	(REC)
L	VCR
R	IN
	(PLAY)
L

DBS DBS tuner

B	D
C

ÅTo audio output

ıTo component video output Ç To S-video output

Î To composite video output

Notes:

•When connecting a DBS tuner to the TV SOUND/DBS IN jacks, change the source name to “DBS,” which will be shown on the display when selected as the source. Otherwise you cannot view any picture from DBS tuner. See page 19 for details.

•When connecting a DBS tuner to the component input jacks (DBS IN), make the component video input setting correctly for AV COMPU LINK. See page 28 for details.

12