JVC CA-UXG45, LVT1520-005B English, To connect the speaker cords, Adjusting the voltage selector

English

To assemble and connect the AM loop antenna

To assemble the AM loop antenna

To connect the AM loop antenna

Make sure to connect the wire correctly: The white end to AM EXT, the black end to GND.

1Hold

2 Insert 3 Release

•If the AM loop antenna wire or speaker cords are covered with vinyl, remove the vinyl to expose the tip of the antenna by twisting the vinyl.

•Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord. Also, keep the antennas away from metallic parts of the System, connecting cords, and the AC power cord. This could cause poor reception.

To connect the speaker cords

Make sure the both speakers are connected correctly and firmly.

3 Release

1 Hold

2 Insert

When connecting the speaker cords, match the polarity of the speaker terminals: The cord with black stripe to (–), the cord without stripe to (+).

• DO NOT connect more than one speaker to each terminal.

•DO NOT allow the conductor of the speaker cords to be in touch with the metallic parts of the System.

Adjusting the voltage selector

Use a screwdriver to slide the voltage selector so that the voltage marker is pointing at the same voltage as where you are plugging in the unit. (See also the back cover page.)

110V-127V

220V-240V

Voltage marker

AC VOLTAGE

SELECTOR

DO NOT plug in before setting the voltage selector on the rear of the unit and all connection procedures are complete.

7