JVC CA-UXG45 English, To connect the USB Memory or DAP, To select a track/group, For MP3 playback

IMPORTANT

•Always set volume to “VOL MIN” when connecting or disconnecting the other equipment.

•Connect the USB Memory or DAP directly to the front panel of the unit. Connecting via a USB hub may result in malfunction.

•USB Memory and DAPs compatible with the USB mass storage class specifications are connectable.

•Some DAPs are not compatible with the unit.

•Coded or encrypted tracks in a special method cannot be played on the unit. Only MP3 is supported.

To connect the USB Memory or DAP

Connect the DAP to the System using the USB cable supplied with the DAP.

or

•Use a USB cable with a “series A” plug at the System end.

•When disconnecting the USB Memory or DAP, make sure that playback is finished and that the System is in the stop condition.

To play back sounds on the USB Memory or DAP

To start: To stop:

USB

MEMORY

•The USB indicator on the display is lit while USB MEMORY is selected.

To select a track/group*

Decreases the track/group* numbers. Increases the track/group* numbers.

*For details about the group selection, see “For MP3 playback” below.

Resume Play for Audio CD/MP3/USB Memory/DAP

•If you press 7during playback, the position of the track where you stopped playback will be memorized by the unit. By pressing CD 6 or USB MEMORY 6, you can start playback again from the point where you stopped it.

To activate/cancel resume play	Remote
	ONLY

When the source is CD or USB MEMORY...

2sec.

SET/RESUME RESUME ON

RESUME OFF

memo

•Pressing 0 or disconnecting the USB Memory/DAP will erase the position of the track where you stopped playback.

•To play back from the first track while resume play is activated, press 7 twice during playback then press CD 6 or USB MEMORY 6.

For MP3 playback

According to the MP3 playback mode, 4/1 / Á/¢ or number buttons work for the group selection or the track selection.

Examples:

When the MP3 play back mode is “GROUP.”

GR (Group) indicator

Total group number				Total track number
You can change the MP3 playback mode
by pressing MP3 MODE.				MP3 MODE
• Each time you press the button, the MP3
playback mode changes as follows:
TRACK			GROUP
TRACK:	• Only tracks are detected (groups are ignored).
	• 4/1, Á/¢, and number buttons
		work for the track selection of the MP3.
GROUP:	• Both groups and tracks are detected.
	• 4/1, Á/¢, and number buttons

work for the group selection of the MP3.

• Number buttons work for selecting the track number within the group.

English

12