JVC LYT0002-0N5A manual EN Getting S Tarted, Loading/Unloading a Cassette

8ENGETTING STARTED (cont.)

T30•45•60 tape length select button Tape Length Setting

Set POWER to “CAMERA”.

Tape length indicator

T30 T30 T45 T60

LCD monitor or viewfinder

2 4

1	3
	5
1

Turn to take up slack.

Erase Protection Gear

Set the tape length according to the length of the tape used.

SET TAPE LENGTH

1 Press T30•45•60 until the required indication appears in the LCD monitor or the veiwfinder. T30 = 30 minutes of recording time, T45 = 45 minutes, and T60 = 60 minutes.

NOTE:

The tape remaining time (☞ pg. 11) displayed in the LCD monitor or the viewfinder is correct only if the correct tape length has been selected.

Loading/Unloading A Cassette

OPEN LCD MONITOR

1 Slide MONITOR OPEN and open the LCD monitor to an angle of over 45 degrees.

OPEN CASSETTE HOLDER

2 Press EJECT until the holder opens. Do not use force to open.

INSERT/REMOVE CASSETTE

3 Make sure the label is facing outward.

CLOSE CASSETTE HOLDER

4 Press PUSH and make sure the holder is closed and locked.

CLOSE LCD MONITOR

5 First make sure the holder is closed. Then close the LCD monitor.

NOTES:

●Closing the LCD monitor while the cassette holder is still open may cause damage to the LCD monitor.

●A cassette holder can’t be opened unless a power supply is attached.

●Make sure that the tape is not slack when loading the cassette. If there is any slack, turn the gear on the cassette in the direction of the arrow to take up the slack.

●Make sure the Erase Protection tab is in the position that allows recording. If not, slide the tab. Some cassettes have removable tabs. If the tab has been removed, cover the hole with adhesive tape.

●The cassette holder can’t be opened while the camcorder is in the record mode.