66 EN
USING REMOTE CONTROL UNIT
(cont.)

SELECT SCENES

ACCESS R.A. EDIT COUNTERDISPLAY
1
Press PLAY/PAUSE, then press ON/OFF and the
counter display appears in the viewfinder and the
screen of the connected TV.
REGISTER BEGINNING OF SCENE
2
Press REW or FF to locate the beginning of a scene
you want, then press IN/OUT to register that point.
The data appears under “IN” on the display.
REGISTER END OF SCENE
3
Press REW or FF to locate the end of the scene and
press IN/OUT to register it. The data appears under
“OUT” on the display. The total time of the
registered scene(s) is displayed at the bottom of the
screen.
REGISTER ADDITIONAL SCENES
4
Repeat steps 2 and 3 for each additional scene
(as many as 8).
MAKE CORRECTIONS
5
Press CANCEL during steps 2 and 3 to erase the
most recently registered point.
NOTES:
●

There must be at least one second between an in-point

and its corresponding out-point.

●

To ensure correct operation, there should be at least 15

seconds between an out-point and the next in-point.

●

Blank portions of tape cannot be registered as in-points

or out-points.

●

If it takes more than 5 minutes to search for an in-point,

the VCR’s Record-Pause mode is cancelled and editing

doesn’t take place.

●

Pressing ON/OFF clears all in- and out-points from

memory.

●

Leave a small margin for error around each in-point to

ensure the scene is recorded in its entirety.

REW
PLAY
IN/OUT
FF
PAUSE
ON/OFF
CANCEL
IN OUT
1 0:00:25 --: --: --
2
3
4
5
6
7
8
COUNTER 0:00:25
TOTAL 0:00:00
IN OUT
1 0:00:25 0:01:05
2 0:03:18 0:03:31
3 0:02:33 0:02:53
4 0:04:11 -- :- -: --
5
6
7
8
COUNTER 0:04:11
TOTAL 0:01:13
FFPLAY/PAUSE
STOP
REW
RM-V709U
(provided)