8
EN
Marks
To AC outlet
CHG. (charge) indicator
REFRESH switch
REFRESH indicator
REFRESH
The AC power adapter features a REFRESH function that allows you to fully discharge the battery pack before recharging.
Perform the REFRESH function after no less than 5 chargings.
To discharge the battery . . .
..... attach the battery pack to the adapter
as shown in the above illustration. Then push REFRESH. The REFRESH indicator lights when discharging starts, and goes out when discharging is complete.
GETTING
STARTED
Power
This camcorder’s
NOTES:
●No function is available without power supply.
●Use only specified power supply.
●Do not use provided power supply units with other equipment.
CHARGING THE BATTERY PACK
SUPPLY POWER
1 Connect the charger’s AC power cord to a wall outlet.
ATTACH BATTERY PACK
2 Align the marks and slide the battery pack in the direction of the arrow until it locks in place.
•The CHG. indicator begins blinking to indicate charging has started.
DETACH BATTERY PACK
3 When the CHG. indicator stops blinking but stays lit, charging is finished. Slide the battery pack opposite the direction of the arrow.
BATT. PACK | CHARGE | DISCHARGE |
|
|
|
approx. 1 hr. 10 min. | approx. 3 hrs. 30 min. | |
|
|
|
approx. 2 hrs. 10 min. | approx. 7 hrs. | |
|
|
|
approx. 2 hrs. 40 min. | approx. 10 hrs. | |
|
|
|
Hook on.
1
2 Push in.
BATT. RELEASE
ATTENTION:
Before detaching the power source, make sure that the camcorder’s power is turned off. Failure to do so can result in a camcorder malfunction.
USING THE BATTERY PACK
ATTACH BATTERY PACK
1 Hook its top end to the camcorder and push the battery pack in until it locks in place.
DETACH BATTERY PACK
2 Slide BATT. RELEASE and pull out the battery pack.
BATT. PACK | Approximate recording time (unit: min.) | |
|
|
|
65 | ( 40 ) | |
|
|
|
135 | ( 85 ) | |
|
|
|
180 | ( 110 ) | |
|
|
|
( ) : when the light is on.
