Getting started
Connecting the FM and AM (MW) antennas
Make sure the antenna conductors do not touch any other terminals, connecting cords and power cords. This could cause poor reception.
7AM (MW) loop antenna
Setting up supplied AM (MW) loop antenna
Attach the AM (MW) loop to its base by snapping the tabs on the loop into the slot on the base.
If the antenna cord is covered with the insulation coat, twist and pull the insulation coat off and remove.
Connecting AM (MW) loop antenna
Center unit
Press and hold down the terminal clamp.
Insert the antenna cord.
If reception is poor
Connect an outdoor single
• Twist together both wires.
AM (MW) loop antenna
Outdoor single
7FM antenna
Connecting supplied FM antenna
Center unit
Extend the supplied FM antenna horizontally.
If reception is poor
Connect an outdoor FM antenna with standard type (75 C coaxial) connector.
Outdoor FM antenna (not supplied)
Outdoor FM antenna cord (not supplied)
Release finger from the clamp.
• Turn the loop antenna until you have the best reception.
NOTE
•Disconnect the supplied FM antenna before attaching a 75 C coaxial connector (the kind with a round wire going to an outdoor antenna).
•We recommend that you use coaxial cable for the FM antenna as it is
9
