JVC M45 For VCR operations, Slide the remote control mode selector to VCR, Press and hold F VCR

Getting started

For VCR operations

You can operate your VCR using the remote control supplied with this system.

• Refer also to the instruction manuals supplied with your VCR.

7To set the manufacturer’s code

1 Slide the remote control mode selector to VCR.

2 Press and hold F VCR.

Keep the button pressed until step 4 is finished.

3 Press ENTER.

4 Press number buttons (1-9, 0) to enter the manufacturer’s code (2 digits).

Examples:

For a Panasonic VCR: Press 2, then 1.

For a Philips VCR: Press 0, then 5.

Manufac-	Code	Manufac-	Code
turer		turer
JVC	01	Nokia	16
Aiwa	02, 20	Nordmende	17	– 19, 31
Bell+Howell	03, 16	Orion	20
Blaupunkt	04	Panasonic	21
CGM	03, 05, 16	Philips	05, 22
Daewoo	34	Phonola	05
Digtal	05	Saba	17 – 19, 23, 31
Fisher	03, 16	Samsung	24, 25
G.E.	06	Sanyo	03, 16
Grundig	07	Sharp	26, 27
Hitachi	08, 09	Siemens	07
Loewe	05, 10, 11	Sony	28	– 30, 35
Magnavox	04, 05	Telefunken	17	– 19, 31, 32
Mitsubishi	12 – 15	Toshiba	33

5 Release F VCR.

6 Try operating your VCR by pressing

FVCR.

When your VCR turns on or off, you have entered the correct code.

If there is more than one cord listed for your brand, try each one until you enter the correct one.

NOTE

•Manufacturers’ codes are subject to change without notice. If they are changed, this remote control cannot operate the equipment.

•Set the codes again after replacing the batteries of the remote control.

7Operation

IMPORTANT

Before using the remote control to operate a VCR;

• Set the remote control mode selector to VCR.

The following buttons are available:

FVCR: Turns VCR on and off. 3(play button): Starts playback.

7 :	Stops operation.
8 :	Pauses playback.
¢:	Fast forwards video tape.
4:	Rewinds video tape.
REC:	Press this button together with 3(play button) to
	start recording or together with 8to pause
	recording.

CHANNEL +/–: Changes the TV channels on the VCR.

16