If the PROGRAM AE dial is set to “ automatically selected.
”, 15S is
RELEASE SELF-TIMER MODE
4 To release when the tally lamp is not blinking, press INT. TIME continuously until “ ” disappears. To release when the tally lamp is blinking, press Recording Start/Stop to stop the blinking, then press INT. TIME continuously until “ ” disappears.
NOTE:
3 Press Recording Start/Stop. The tally lamp begins blinking, and the blinking speed increases about
5 seconds before recording starts. When recording begins, the lamp stops blinking but stays lit.
SET TIME DELAY
Make sure the lens cover is open, set the power switch to CAMERA.
1
2 On the remote control, press INT. TIME to set the delay time. There are four choices, and they appear in the viewfinder in the following order (each time INT. TIME is pressed): 15S (15 seconds), 30S
(30 seconds), 1MIN (1 minute) and 5MIN
(5 minutes). Pressing again releases the Self-timer.
You can set the delay between pressing Recording Start/ Stop and the actual start of recording. If you secure the camcorder, you (or whomever is operating the camcorder) can enter the scene before recording starts.
NOTE:
You need the RM-V705U or RM-V700U remote control unit to perform this procedure.
ENGAGE RECORD–STANDBY MODE
Advanced Features
26
RECORDING
Tally lamp PROGRAM AE
START/STOP
INT. TIME
REC TIME
| OR |
| START DELAYED RECORDING |
| |||
(optional) |
|
|
|
|
|
|
|
