Recording
Continued
IMPORTANT:
•It should be noted that it may be unlawful to
•The recording level is automatically set correctly, so it is not affected by the VOLUME control. Thus, during recording you can adjust the sound you are actually listening to without affecting the recording level.
•While recording, you can hear sound modes and/or the Signal Adaptive Bass effect through the speakers or headphones. However, the sound is recorded without these effects (see page 11).
•If recordings you have made have excessive noise or static, the unit may be too close to a TV. Increase the distance between the TV and the unit.
•You can use type I and II tapes for recording.
Recording Tapes on Deck B
1 Press EJECT 0 for the deck B.
2 Put in a recordable cassette, with the exposed part of the tape down.
3 Close the cassette holder gently.
4 Check the tape direction of deck B.
•If the tape direction is not correct, press TAPE 2 3 twice then 7to change the tape direction.
To protect your recording
Cassettes have two small tabs on the back to protect unexpected erasure or
To protect your recording, remove these tabs.
To
When using type II tape, be careful not to cover the holes used to detect the tape type.
5 Start playing the source — FM, AM*, CD player, deck A, or auxiliary equipment connected to AUX jacks.
•When the source is CD, you can also use CD Direct Recording (see page 21) and Auto Edit Recording (see page 22).
•When the source is deck A, you can also use the dubbing method. (See “Dubbing Tapes” on page 21.)
* See “To record an AM station – Beat Cut” on page 21.
6 Start recording. On the unit:
Press REC START/STOP.
The indicator lights up on the display and recording starts.
On the remote control:
1)Press REC PAUSE.
The indicator starts flashing on the display.
2)Press TAPE 23.
The indicator stops flashing and remains lit, and recording starts.
To stop during recording, press REC START/ STOP again (or 7 on the remote control).
REC
START/STOP
REC PAUSE
– 20 –
20 | 99.2.9, 1:34 PM |