JVC PIM171200 manual To change the FM tuner selectivity, If Filter

ENGLISH

To select the subwoofer cutoff frequency

—WooferFreq (only for KD-LX333R)

When a subwoofer is connected to this unit, select an appropriate cutoff frequency level for your subwoofer. When shipped from the factory, the subwoofer cutoff frequency is set to “FREQ MID.”

•FREQ LOW: Frequencies higher than 50 Hz are cut off to the subwoofer.

•FREQ MID: Frequencies higher than 80 Hz are cut off to the subwoofer.

•FREQ HIGH: Frequencies higher than 120 Hz are cut off to the subwoofer.

To adjust the line input level — LINE ADJ

(only for KD-LX333R)

Adjust the line input level properly when an external component is connected to the LINE INPUT plugs. When shipped from the factory, the line input level is set at level “00.”

If the input level of the connected component is not high enough, increase the input level properly. Without adjusting the line input level, you may be surprised at a loud sound when you change from the external component to another source.

To select the external component to use

––EXT INPUT (only for KD-LX111R)

You can connect the external component to the CD changer jack on the rear using the Line Input Adaptor KS-U57 (not supplied).

To use the external component as the playback source through this unit, you need to select which component – CD changer or external component – to use. When shipped from the factory, CD changer is selected as the external component.

•LINE INPUT: To use the external component other than CD changer.

•CD CHANGER:To use the CD changer.

Note:

For connecting the Line Input Adaptor KS-U57 and the external component, refer to the Installation/ Connection Manual (separate volume).

To make the front panel look flat (hiding the control panel) — FLAT PANEL

When operating the receiver using the remote control, you can hide the control panel to make the front panel look flat. When shipped from the factory, “FLAT OFF” is selected.

• FLAT ON:	The control panel will not come
	out when you turn on the unit.
	To use the control panel, press
	4	so that the control
	panel comes out. If no
	operation is done for about 10
	seconds, it automatically goes
	back into the receiver.
• FLAT OFF:	You can use the control panel
	normally.

Note:

When “FLAT ON” is selected, you can eject a CD by

holding 4 .

To change the FM tuner selectivity

—IF FILTER

In some areas, adjacent stations may interfere with each other. If this interference occurs, noise may be heard. This unit has been preset to automatically reduce this interference noise (“AUTO”) when shipped from the factory.

•	AUTO:	When this type of interference
		occurs, this unit automatically
		increases the tuner selectivity
		so that interference noise will
		be reduced. (But the stereo
		effect will also be lost.)
•	WIDE:	Subject to the interference from
		adjacent stations, but sound
		quality will not be degraded
		and the stereo effect will not be
		lost.

28