Controlling the volume automatically (Audio Cruise)
This section is only for KD-LX333R.
You can select the proper cruise mode for your car.
This unit changes the volume level automatically (at 3 possible levels) based on the driving speed of your car by detecting the alternator’s generating frequency (Audio Cruise).
If you want to use this mode, follow the procedure below. When shipped from the factory, this mode is set to “CRUISE OFF.”
•CRUISE 1: Select this if your car is relatively quiet.
•CRUISE 2: Select this if your car is relatively loud.
The volume increase rate is twice as much as that of the CRUISE 1 setting.
•CRUISE OFF: Cancels Audio Cruise.
1 Press and hold SEL (S) for more than 2 seconds so that one of the PSM items appears on the display. (See pages 25 and 26.)
SEL
S
2 Select “CRUISE” if not shown on the display.
3 Select the desired setting. |
| |
ENGLISH | ||
As you turn the control dial, the Audio Cruise | ||
| ||
mode changes as follows: |
| |
|
|
CRUISE 1 
CRUISE 2 
CRUISE OFF 
4 Finish the setting.
SEL
S
To adjust the volume increase rate
If you find Audio Cruise increases (or decreases) the volume either too much or too little as the driving speed changes, you can adjust the increase rate by changing the boost level.
To change it, follow the procedure below.
•See also “Changing the general settings (PSM)” on page 25.
1 Press and hold SEL (S) for more than 2 seconds so that one of the PSM items appears on the display.
2 Press 
¢ or 4 
repeatedly until “CRUISE” appears on the display.
3 Turn the control dial to select either “CRUISE 1” or “CRUISE 2.”
4 Press 
¢(or 4 
) to select “BOOST.” The current boost level also appears on the display.
5 Turn the control dial to select the desired boost level (among 01 to 15).
6 Press SEL (S) to finish the setting.
29
