ENGLISH
Canceling the demonstration
When shipped from the factory, demonstration has been activated, and starts automatically when no operations are done for about 20 seconds.
•It is recommended to cancel the demonstration before you use the unit for the first time.
To cancel the demonstration, follow the
procedure below.
1 Press and hold SEL (S) for more than 2 seconds so that one of the PSM items appears on the display. (See pages 25 and 26.)
SEL
S
2 Select “DEMO MODE” if not shown on the display.
3 Select “DEMO OFF.”
Setting the clock
1 Press and hold SEL (S) for more than 2 seconds so that one of the PSM items appears on the display. (See pages 25 and 26.)
SEL
S
2 Set the hour.
1Select “CLOCK HOUR” if not shown on the display.
2Adjust the hour.
1 2
3 Set the minute.
1Select “CLOCK MIN (minute).”
2 Adjust the minute.
1 2
4 Set the clock system.
1 Select “24H/12H.”
2 Adjust “24HOUR” or “12HOUR.”
1 
2
4 Finish the setting.
SEL
S
5 Finish the setting.
To activate the demonstration again, repeat
the same procedure and select “DEMO ON” in step 3.
SEL
S
To check the current clock time with “CLOCK DISP” set to “CLOCK OFF,” press DISP (D).
The clock time is shown for 5 seconds.
8
