Getting Started

Do not connect the AC power cord until all other connections have been made.

This section explains how to connect audio/video components and speakers to the receiver, and how to connect the power supply.

Before Installation

Note:

Supplied batteries are for the initial setup. Replace for continued use.

General Precautions

Be sure your hands are dry.

Turn the power off to all components.

Read the manuals supplied with the components you are going to connect.

Locations

Install the receiver in a location that is level and protected from moisture and dust.

The temperature around the receiver must be between –5˚C and 35˚C.

Make sure there is good ventilation around the receiver. Poor ventilation could cause overheating and damage the receiver.

Handling the receiver

CAUTION:

Follow these precautions to avoid leaking or cracking cells:

Place batteries in the remote control so they match the polarity: (+) to (+) and (–) to (–).

Use the correct type of batteries. Batteries that look similar may differ in voltage.

Always replace both batteries at the same time.

Do not expose batteries to heat or flame.

Connecting the FM and AM (MW)

Antennas

FM antenna connections

Do not insert any metal object into the receiver.

Do not disassemble the receiver or remove screws, covers, or cabinet.

Do not expose the receiver to rain or moisture.

Checking the Supplied Accessories

Check to be sure you have all of the following items, which are supplied with the receiver.

The number in the parentheses indicates quantity of the pieces supplied.

Remote Control (1)

Batteries (2)

AM (MW) Loop Antenna (1)

FM Antenna (1)

If anything is missing, contact your dealer immediately.

AB

 

AM

 

AM

EXT

LOOP

EXT

LOOP

AM

 

AM

 

ANTENNA

ANTENNA

Extend the supplied FM antenna horizontally.

Putting Batteries in the Remote Control

Before using the remote control, insert the two supplied batteries first.

1

2 R6(SUM-3)/

3

 

AA(15F)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1Press and slide the battery cover on the back of the remote control.

2Insert the batteries.

• Make sure to match the polarity: (+) to (+) and (–) to (–).

3Replace the cover.

If the remote control cannot transmit signals or operate the receiver correctly, replace the batteries. Use two R6(SUM-3)/AA(15F) type dry-cell batteries.

AM EXT

AM

FM Antenna

(supplied)

LOOP

ANTENNA

Outdoor FM Antenna Cable

 

 

(not supplied)

Connect the supplied FM antenna as temporary measure to the FM 75 COAXIAL terminal—A

If reception is poor, connect the outdoor FM antenna (not supplied)—B

1Disconnect the supplied FM antenna.

2Connect a 75 coaxial cable with the standard type connector (IEC or DIN45325).

4

Page 85
Image 85
JVC RX-5060B manual Connecting the FM and AM MW Antennas, Remote Control Batteries AM MW Loop Antenna FM Antenna