JVC RX-5060B manual Using the DSP Modes

Using the DSP Modes

All Channel Stereo

This mode can reproduce a larger stereo sound field using all the connected (and activated) speakers.

•If the surround speakers are set to “NONE,” you cannot select “ALL CH STEREO.”

Sound reproduced from normal stereo

Sound reproduced from All Channel Stereo mode

Activating the DSP Modes

Activating one of the DSP modes for a source automatically recalls the memorized settings and adjustments (see pages 19 to 25).

1Select and play any source.

2Press DSP repeatedly until the DSP mode you want appears on the display.

•Each time you press the button, the DSP modes change as follows:

DSP

= HALL 1	= HALL 2	= LIVE CLUB
= DANCE CLUB	= PAVILION	= ALL CH STEREO
= THEATER 1	= THEATER 2	= MONO FILM

=(Back to the beginning)

Note:

When the surround speakers are set to “NONE,” the 3D-PHONIC processing is applied to the DSP modes (the 3D-PHONIC indicator also lights up).

To adjust the effect level (except All Channel Stereo) and center

tone, see page 25.

Mono Film

In order to reproduce a more acoustic sound field in your listening room while viewing monaural sound video software (analog and 2-channel digital signals), you can use this mode.

The surround effect will be added, and the sound localization of actor’s words will be improved. This mode cannot be used for

multi-channel digital signals.

When “MONO FILM” is used, the sounds come out of all the connected and activated speakers.

•If surround speakers are set to “NONE” in the speaker setting, JVC’s original 3D-PHONIC processing (which has been developed to create the surround effect through the front speakers only) is used. The 3D-PHONIC indicator lights up on the display.

•If incoming signals change from 2-channel digital signal to another digital signal type, “MONO FILM” is canceled and an appropriate Surround mode is activated.

To cancel the DSP mode

Press SURROUND/DSP OFF.

30