JVC RX-6008VBK Select the low frequency effect Attenuator level, Crossover Frequency Setting

Crossover Frequency Setting

Small speaker cannot reproduce the bass sound very well. So, if you have used a small speaker any for the front, center, or rear channels, this receiver automatically reallocates the bass elements, originally assigned to the channel for which you have connected the small speaker, to another channel (for which you have connected the large

Low Frequency Effect Attenuator Setting

If the bass sound is distorted while playing back a source using Dolby Digital or DTS Digital Surround, follow the procedure below.

•This function takes effect only when the subwoofer (LFE) signals come in. (with “SUBWOOFER” set to “Yes.”)

English

speaker).

If you have selected “LARGE” for all speakers (see page 12), this function will not take effect. To use this function properly, you need to set this crossover frequency level according to the size of the small speaker connected.

This function takes effect in the following cases:

On the front panel ONLY:

1. Press SETTING repeatedly until “LFE ATT” (Low Frequency Effect Attenuator) appears on the display.

SETTING

-When playing a source using Dolby Pro Logic, Dolby Digital, or DTS Digital Surround.

-When using the DAP modes.

•Once you have pressed SETTING, MULTI CURSOR %/ Þ can be also used for selecting “LFE ATT.”

•The display changes to show the current setting.

On the front panel ONLY:

1. Press SETTING repeatedly until “CROSSOVER FRQ” (Crossover Frequency) appears on the display.

SETTING

2. Press MULTI CURSOR @/ #to	MULTI CURSOR
select the low frequency effect
attenuator level.

• As you press it, the display changes to show the following:

•Once you have pressed SETTING, MULTI CURSOR %/ Þ can be also used for selecting “CROSSOVER FRQ.”

•The display changes to show the current setting.

MULTI CURSOR

2.Press MULTI CURSOR @/ #to select the crossover frequency level according to the size of the small speaker connected.

• As you press it, the display changes to show the following:

80Hz100Hz120Hz

• Use the following comments as reference when adjusting.

80Hz: Select this when the cone speaker unit built in the speaker is about 12 cm.

100Hz: Select this when the cone speaker unit built in the speaker is about 10 cm.

120Hz: Select this when the cone speaker unit built in the speaker is about 8 cm.

0dB 10dB

0dB: Normally select this.

10dB: Select this when the bass sound is distorted.

Dynamic Range Compression Setting

You can compress the dynamic range (difference between maximum sound and minimum sound) of the reproduced sound. This is useful when enjoying surround sound at night.

•This function takes effect only when playing back a source using Dolby Digital.

On the front panel ONLY:

1. Press SETTING repeatedly until	SETTING
“D. RANGE COMP.” (Dynamic
Range Compression) appears on
the display.

•Once you have pressed SETTING, MULTI CURSOR %/ Þ can be also used for selecting “D. RANGE COMP.”

•The display changes to show the current setting.

MULTI CURSOR

2.Press MULTI CURSOR @/ #to select the appropriate item about the compression level.

•As you press it, the display changes to show the following:

OFF MID MAX

OFF: Select this when you want to enjoy surround with its full dynamic range. (No effect applied)

MID: Select this when you want to reduce the dynamic range a little. (Factory setting)

MAX: Select this when you want to apply the compression effect fully. (Useful at night)

13