JVC RX-6008VBK Storing the Basic Settings Adjustments One Touch Operation, Using the Sleep Timer

Storing the Basic Settings and

Adjustments — One Touch Operation

JVC’s One Touch Operation function is used to assign and store different sound settings for each different playing source. By using this function, you do not have to change the settings every time you change the source. The stored settings for the newly selected source are automatically recalled.

Using the Sleep Timer

Using the Sleep Timer, you can fall asleep to music and know the receiver will turn off by itself rather than play all night.

From the remote control ONLY:

Press SLEEP repeatedly. SLEEP

The SLEEP indicator lights up on the display, and the shut-off time changes as follows (in

English

The following can be stored for each source:

•Volume level (see page 9)

•Bass boost (see page 10)

•Tone adjustment (see page 10)

•Input attenuator mode (see page 10)

•Subwoofer output level (see page 10)

•Balance (see page 11)

•DSP modes

–3D-PHONIC mode settings (see page 21)

–DAP mode settings (see page 21)

–Surround mode settings (see page 22)

On the front panel ONLY:

To store the sound settings

1.Press ONE TOUCH OPERATION (INPUT ATT.) so that the ONE TOUCH OPERATION indicator lights up on the display.

ONE TOUCH OPERATION/

INPUT ATT.

minutes):

10 20 30 40 50 60 70 80 90

00(Canceled)

When the shut-off time comes

The receiver turns off automatically.

To check or change the time remaining until the shut-off time

Press SLEEP once.

The remaining time until the shut-off time appears in minutes.

• To change the shut-off time, press SLEEP repeatedly.

To cancel the Sleep Timer

Press SLEEP repeatedly until “SLEEP 00min.” appears on the display. (The SLEEP indicator goes off.)

• Turning off the power also cancels the Sleep Timer.

2. Adjust the sound using the functions listed above.

The newly adjusted settings are memorized.

To recall the sound settings

With the ONE TOUCH OPERATION lamp lit, the settings for the currently selected source are recalled when the source is selected.

To cancel the One Touch Operation function

Press ONE TOUCH OPERATION (INPUT ATT.) so that the ONE TOUCH OPERATION indicator goes off.

(Even though the One Touch Operation function is canceled, the recalled sound effects remain active.)

Note:

If the source is FM or AM, you can assign a different setting for each band.

15