English
Digital Input (DIGITAL IN) Terminal
Setting
When you use the digital input terminals, you have to register what components are connected to which terminals (DIGITAL IN 1/2).
Before you start, remember...
•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
On the front panel ONLY:
1. Press SETTING repeatedly until | SETTING |
“DIGITAL IN” appears on the |
|
display.
•Once you have pressed SETTING, MULTI CURSOR %/ Þ can be also used for selecting “DIGITAL IN.”
•The display changes to show the current setting.
DIGITAL 2 terminal setting
DIGITAL 1 terminal setting
2. Press MULTI CURSOR @/ #to | MULTI CURSOR |
select an appropriate setting. |
|
•As you press it, the display changes to show
the following:
1 DVD 2 CD Ò 1 DVD 2 DBS Ò 1 DVD 2 MD Ò
1 CD 2 DVD Ò 1 CD 2 DBS | Ò 1 CD 2 MD Ò |
1 DBS 2 DVD Ò 1 DBS 2 CD | Ò 1 DBS 2 MD Ò |
1 MD 2 DVD Ò 1 MD 2 CD | Ò 1 MD 2 DBS Ò |
(back to the beginning) |
|
Note:
When shipped from the factory, the DIGITAL IN terminals can be used as the digital input for the following components.
•DIGITAL 1 (coaxial): For DVD player
•DIGITAL 2 (optical): For CD player
Selecting the Analog or Digital Input Mode
When you have connected some digital source components using the digital terminals (see page 7), you need to change the input mode for these components to the appropriate digital input mode correctly — AUTO/PCM, DOLBY DIGITAL, or DTS.
Once the correct mode is selected for each digital source component, the mode is memorized until you change it.
1.Follow the steps in “Digital Input (DIGITAL IN) Terminal Setting” to the left.
2.Press the source selecting button (CD, TAPE/MD, TV SOUND/DBS, or DVD) for which you want to change the input mode from analog input to digital input.
DVD | TV SOUND/DBS | DVD | TV SOUND/DBS |
| SOURCE NAME |
|
|
CD | TAPE/MD | CD | TAPE/MD |
| SOURCE NAME |
|
|
On the front panel | On the remote control |
3.Press ANALOG/DIGITAL repeatedly until the digital input mode you want appears on the display.
ANALOG/DIGITAL
ANALOG/DIGITAL
DIGITAL AUTO
On the front panel | On the remote control |
Each time you press the button, the input mode changes as follows:
ANALOG 
AUTO/PCM
(Digital)
DTS 
DOLBY DIGITAL 
(Digital)(Digital)
Normally select “AUTO/PCM,” so the receiver automatically detects the incoming digital signal. The DIGITAL AUTO indicator lights up on the display. (The DIGITAL AUTO lamp next to the ANALOG/DIGITAL button lights up.)
-When the receiver can recognize the digital signal coming into the receiver, the frame of the digital signal indicator for the detected signal lights up automatically.
-When the receiver cannot recognize the incoming signal correctly, the frame of the digital signal indicator flashes. If this happens, select the same digital input mode with the incoming digital signal — either “DOLBY DIGITAL” or “DTS.”
Notes:
•Noise may come out of the speakers while searching or skipping a
•When you change the source, the digital input mode will be automatically reset to “AUTO/PCM.”
14
