JVC RX-6000VBK, RX-6008VBK Adjusting the Surround Modes, 10 +10, English, Press SURROUND MODE

English

From the remote control:

1. Press SURROUND MODE

SURROUND

repeatedly until the DAP mode —

LIVE CLUB, DANCE CLUB,

SURROUND

HALL, PAVILION, or HEADMODE PHONE — appears on the display.

The DSP indicator also lights up on the display. (When the HEAD PHONE is selected, HEAD PHONE indicator lights up, instead of the DSP indicator .)

•When you have set “REAR SPK” to “NONE,” the 3D- PHONIC indicator also lights up. (Except for “HEAD PHONE.”)

Adjusting the Surround Modes

Once you have adjusted the Surround modes, the adjustment is memorized for each Surround mode.

Dolby and DTS Surround adjustments

Before you start, remember...

• Make sure that you have set the speaker information correctly

(see page 12).

• There is a time limit in doing the following steps. If the setting is

canceled before you finish, start from step 1 again.

• You cannot adjust the rear speaker output levels when you have set

“REAR SPK” to “NONE.” See page 12.

• You cannot adjust the center speaker output level when you have

2. Press SOUND.

SOUND

set “CENTER SPK” to “NONE.” See page 12.

The 10 keys are activated for sound adjustments.

From the remote control:

1. Press SURROUND to activate an

appropriate Surround mode —

SURROUND

3.Adjust the rear speaker output levels.

•To adjust the left rear speaker level, press REAR•L –/+ (from –10 dB to +10 dB).

•To adjust the right rear speaker level, press REAR•R –/+ (from –10 dB to +10 dB).

– REAR•L +

8 9

MENU

– REAR•R +

10 +10

ENTER

PRO LOGIC, DOLBY DIGITAL

or DTS SURROUND.SURROUND

MODE

•Each time you press the button, the Surround mode turns on and off alternately.

•When “PRO LOGIC” is selected, the Ù PRO LOGIC indicator lights up on the display.

Note:

You can also press SURROUND MODE to activate an appropriate

Surround mode — PRO LOGIC, DOLBY DIGITAL, or DTS.

4. Press EFFECT to select an effect	EFFECT
	4
level you want.

•Each time you press the button, the effect level changes as follows:

DSP EFFECT 1 DSP EFFECT 2 DSP EFFECT 3

DSP EFFECT 5 DSP EFFECT 4

As the number increases, the selected DAP mode becomes stronger.

2. Press SOUND. SOUND

The 10 keys are activated for sound adjustments.

3. Press TEST to check the speaker					TEST
	output balance.
					1
	“TEST TONE L” starts flashing on the
	display, and a test tone comes out of the
	speakers in the following order:
	TEST TONE L		TEST TONE C		TEST TONE R
	(Left front speaker)		(Center speaker)		(Right front speaker)
		TEST TONE LS		TEST TONE RS
		(Left rear speaker)		(Right rear speaker)

Notes:

•You can adjust the speaker output levels without outputting the test tone.

•No test tone comes out of the center speaker when “CENTER SPK” is set to “NONE” (see page 12).

•No test tone comes out of the rear speakers when “REAR SPK” is set to “NONE” (see page 12).

22