One Touch Operation
This receiver can memorize the optimum sound settings for each playing source.
About the One Touch Operation
JVC’s One Touch Operation function is used to assign and store different sound settings for each different playing source. By using this function, you don’t have to change the settings every time you change the source. The stored settings for the newly selected source are automatically recalled.
The following can be stored for each source:
•Volume level (see page 13)
•Balance (see page 15)
•Loudness (see page 15)
•SEA modes (see page 26)
•Surround mode settings (see page 28)
Note:
If the source is FM or AM (MW/LW), the One Touch Operation function works only when the preset channels from 1 — 20 are tuned in. You can assign a different setting for each preset channel.
Using the One Touch Operation
To store the sound settings
ONE TOUCH1. Press ONE TOUCH OPERATION.
OPERATION
The ONE TOUCH OPERATION lamp lights up, then the previously memorized settings are recalled and appear on the display in turn.
2. Adjust the sound using the functions listed above.
English
Front panel
The newly adjusted settings are memorized.
| To recall the sound settings | |
| With the ONE TOUCH OPERATION lamp lit, the settings for the currently selected source is recalled, and | |
ONE TOUCH | appears on the display when the source is selected. | |
| ||
OPERATION |
| |
| To cancel the One Touch Operation function | |
Remote Control | Press ONE TOUCH OPERATION so that the lamp goes off. | |
(Even though the One Touch Operation function is canceled, the recalled sound effects remain active.) | ||
|
Page 18