On the front panel:
1Start playing 2 channel
2 Press SURROUND ON/OFF to activate Surround mode.
When Surround mode turns on, the last selected
Surround mode will be activated.
•Each time you press the button, Surround mode turns on and off alternately.
3 Press SURROUND MODE repeatedly
until one of the DAP
and
The DSP indicator also lights up on the display.
5For DAP modes only: Adjust the effect level.
1) Press ADJUST repeatedly until “EFFECT” (with the current setting)* appears on the display.
*“EFFECT 3” is the initial setting. If you have already changed the setting, another setting will be shown.
2) Press CONTROL UP 5/DOWN ∞ CONTROL
DOWN UP
to select the effect level (1 to 5) you want.
•Each time you press the button, the effect level changes as follows:
EFFECT 1 EFFECT 2 EFFECT 3
EFFECT 5 |
| EFFECT 4 |
|
As the number increases, the selected mode becomes stronger (normally set it to “EFFECT 3”).
English
If you like to adjust sound, go to step 4.
4 Adjust the speaker output levels. |
| To cancel DAP modes and All Channel Stereo |
| Press SURROUND ON/OFF again so that “SURROUND OFF” | |
1) Press ADJUST repeatedly until one | ADJUST SETTIN appears on the display. The DSP indicator goes off. | |
of the following indications (with the |
|
|
|
| |
current setting)* appears on the |
|
|
display. |
|
|
REAR L : To adjust the left rear speaker output level
REAR R : To adjust the right rear speaker output level
CENTER : For “ALL CH STEREO”
*“0” is the initial setting. If you have already changed the setting, another number (level) will be shown.
2) Press CONTROL UP 5/DOWN ∞ CONTROL
DOWN UP
to adjust the selected speaker output levels.
3)Repeat steps 1) and 2) to adjust the other speaker levels.
29