“NO” for the subwoofer, “LARGE” for the front speakers, and “SMALL” for the center and rear speakers are initial settings. To get best possible sound, change the subwoofer and speaker settings to fit your listening conditions.
Connecting the Speakers
Speaker layout diagram
Center speaker
Left front | Right front |
speaker | Subwoofer speaker |
Left rear | Right rear |
speaker | speaker |
After connecting the front, center, rear speakers and/or subwoofer, set the speaker setting information properly to obtain the best possible Surround effects. For details, see pages 16 to 18.
CAUTION:
Use speakers with the SPEAKER IMPEDANCE indicated by the
speaker terminals.
Connecting the front speakers
You can connect two pairs of front speakers (one pair to the FRONT SPEAKERS 1 terminals, and the other pair to the FRONT SPEAKERS 2 terminals).
About the speaker impedance
The required speaker impedance of the front speakers does differ depending on whether both the FRONT SPEAKERS 1and FRONT SPEAKERS 2 terminals are used or only one of them is used.
CASE 1 When you connect only one pair of front speakers
Front | Front |
speaker | speaker |
1 | 1 |
Use front speakers with 8 Ω – 16 Ω impedance.
CASE 2 When you connect two pairs of front speakers
FrontFront
speaker speaker
2 | 2 |
Front | Front |
speaker | speaker |
1 | 1 |
Use front speakers with 16 Ω – 32 Ω impedance.
Connection diagram
FRONT
SPEAKERS
1
1 | FRONT | 2 |
SPEAKERS | ||
| + | + |
| – | – |
| RIGHT | LEFT |
RIGHT | LEFT |
|
FRONT
SPEAKERS
2
Connecting speakers to the FRONT SPEAKERS 1 terminals
1 | 2 |
| 3 | 4 |
| 1 |
| 1 | 1 |
| RIGHT |
| RIGHT | RIGHT |
|
| LEFT | LEFT | LEFT |
For each speaker, connect the (+) and
1Cut, twist and remove the insulation at the end of each speaker signal cable (not supplied).
2Turn the knob counterclockwise.
3Insert the speaker signal cable.
4Turn the knob clockwise.
Connecting speakers to the FRONT SPEAKERS 2 terminals
1 | 2 | 3 |
1
2
For each speaker, connect the (+) and
1Cut, twist and remove the insulation at the end of each speaker cord.
2Open the terminal (1), then insert the speaker cord (2).
3Close the terminal.
English
5