JVC RX-7520VBK Basic adjustment auto memory, For recording, Speaker indicators light up when

Basic adjustment auto memory

This receiver memorizes sound settings for each source when—:

•turning off the power,

•changing the source, and

•assigning the source name.

When you change the source, the memorized settings for the newly selected source are automatically recalled.

The following can be stored for each source:

•Input attenuator mode (see page 19)

•Balance (see page 19)

•Tone adjustment (see page 20)

•Subwoofer output level (see page 20)

•Surround mode selection (see pages 26 – 29)

•Bass boost (see page 20)

Notes:

•You cannot assign and store different settings for digital input mode and analog input mode.

•If the source is FM or AM, you can assign a different setting for each band.

For recording

You can record any source through the receiver to —:

•the cassette deck (or CD recorder) connected to the TAPE/CDR jacks, and

•the VCR connected to the VCR jacks at the same time.

While recording, you can listen to the selected sound source at whatever sound level you like without affecting the sound levels of the recording.

Note:

The output volume level, bass boost (see page 20), tone adjustment (see page 20), and Surround modes (see page 23) cannot affect the recording.

Signal and speaker indicators on the display

Signal indicators					Speaker indicators
L	C	R				L	C	R
			ANALOG	SPK 1 2
			DIGITAL AUTO	L C R	PROLOGIC ΙΙ
S.WFR LFE			LINEAR PCM	S.WFR LFE		S.WFR LFE
			DIGITAL	CH-
				LS S RS
LS	S	RS
						LS	S	RS

The following signal indicators light up—:

L: •When digital input is selected: Lights up when the left channel signal comes in.

•When analog input is selected: Always lights up.

R: • When digital input is selected: Lights up when the right channel signal comes in.

•When analog input is selected: Always lights up.

C: When the center channel signal comes in. LS : When the left rear channel signal comes in. RS : When the right rear channel signal comes in.

S : When the monaural rear channel signal or 2 ch Dolby Surround encoded signal comes in.

LFE: When the LFE channel signal comes in.

The speaker indicators light up when—:

•The corresponding speaker is activated, and

•The corresponding speaker is required for the current playback.

Notes:

•When you select “DVD MULTI,” all the signal indicators except “S” light up.

• When “SUBWOOFER” is set to “YES” (see page 16), S.WFR

lights up.

English

13