JVC RX-7520VBK Operating JVC’s Audio/Video Components, Operating Audio Components, Tuner, English

Operating JVC’s Audio/Video Components

English

You can use the remote control to operate other JVC’s components.

Operating Audio Components

FM MODE

Sound Adjustment

You can always use the following buttons:

SURROUND ON/OFF : Turn on or off the Surround modes.

SURROUND MODE : Select the Surround modes.

After pressing SOUND, you can use the following buttons for sound adjustment:

SUBWOOFER +/–	: Adjust the subwoofer output level.
CENTER +/–	: Adjust the center speaker output level.
REAR•L +/–	: Adjust the left rear speaker output level.
REAR•R +/–	: Adjust the right rear speaker output level.
EFFECT	: Select the DAP effect level.
TEST	: Turn on or off the test tone output.

Note:

After adjusting sounds, press the corresponding source selecting button or CD–DISC to operate your target source by using the 10 keys; otherwise, the 10 keys cannot be used for operating your target source.

Tuner

You can always use the following buttons:

FM/AM	: Alternate between FM and AM.
FM MODE	: Change the FM reception mode.

After pressing FM/AM, you can use the following buttons for tuner operations:

1 – 10, +10: Select a preset channel number directly.

• For channel number 5, press 5.

• For channel number 15, press +10, then 5.

• For channel number 20, press +10, then 10.

IMPORTANT:

To operate JVC’s audio components using this remote control:

•You need to connect JVC’s audio components through the COMPU LINK-4 (SYNCHRO) jacks (see page 31) in addition to the connections using cables with RCA pin plugs (see pages 6 and 7).

•Aim the remote control directly at the remote sensor on the receiver.

•If you use the buttons on the front panel, the remote control will not operate that source. To operate a source with the remote control, the source must be selected using source selecting buttons on the remote control.

•To operate the cassette deck or CD recorder using the COMPU LINK remote control system, set the source name correctly. (See page 11.)

•Refer also to the manuals supplied with your audio components.

CD player

After pressing CD, you can use the following buttons for CD operations:

3	: Start playback.
4	: Return to the beginning of the current
	(or previous) track.
¢	: Skip to the beginning of the next track.
7	: Stop playback.
8	: Pause playback. To release it, press 3.
1 – 10, +10	: Select a track number directly.
	• For track number 5, press 5.
	• For track number 15, press +10, then 5.
	• For track number 20, press +10, then 10.

34