JVC RX-7520VBK Using DVD MULTI Playback Mode, Activating DVD MULTI Playback Mode, Press DVD MULTI

Using DVD MULTI Playback Mode

English

This receiver provides the DVD MULTI playback mode for reproducing the analog discrete output mode of the DVD player. Before playing back a DVD, refer also to the manual supplied with the DVD player.

Activating DVD MULTI Playback Mode

You can adjust the DVD MULTI playback mode while playing back a DVD using the analog discrete output mode on the DVD player. Once you have made adjustments, the receiver memorizes the adjustments until you change them.

You also need to set the DVD player to the analog discrete output mode.

Before you start, remember....

There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

From the remote control:

1 Press DVD MULTI. DVD MULTI

Note:

When you select “DVD MULTI” as the source to play, Surround mode is canceled, and the SURROUND ON/OFF and SURROUND MODE buttons do not work.

2Select the analog discrete output mode on the DVD player, and start playing a DVD.

•Refer also to the manual supplied with the DVD player.

If you need to make any adjustments, go to the following steps.

3 Press SOUND.	SOUND
The 10 keys are activated for adjusting the sound.

On the front panel:			4 Adjust the speaker output levels.
1 Press DVD MULTI.
		DVD MULTI	• To adjust the center speaker level, press
	Notes:		CENTER +/– (–10 to +10).
	• When you select “DVD MULTI” as the source to play, the
	Surround mode is canceled, and the SURROUND ON/OFF and		• To adjust the left rear speaker level, press
	SURROUND MODE buttons do not work.
			REAR•L +/– (–10 to +10).
	• If you select DVD MULTI as the source while using both the
	speakers connected to the FRONT SPEAKERS 1 and 2
	terminals, the speakers connected to the FRONT SPEAKERS		• To adjust the right rear speaker level, press
	2 terminals are deactivated.
	• When selecting “DVD MULTI” as the source, you can only		REAR•R +/– (–10 to +10).

select either the speakers connected to the FRONT SPEAKERS 1 or 2 terminals.

CENTER

2 3

REAR L

5 6

REARR

8 9

2Select the analog discrete output mode on the DVD player, and start playing a DVD.

•Refer also to the manual supplied with the DVD player.

If you need to make any adjustments, go to the following steps.

3Adjust the speaker output levels.

1)Press ADJUST repeatedly until one of ADJUST SETTING

the following indications appears on the display.

CENTER :To adjust the center speaker output level (–10 to +10).

REAR L : To adjust the left rear speaker output level (–10 to +10).

REAR R : To adjust the right rear speaker output level (–10 to +10).

2) Press CONTROL UP 5/DOWN ∞ CONTROL

DOWN UP

to adjust the selected speaker output levels.

3)Repeat steps 1) and 2) to adjust the other speaker output levels.

30