2. Press INPUT ANALOG/DIGITAL | INPUT |
ANALOG/DIGITAL | |
repeatedly until the digital input |
|
mode you want appears on the |
|
display. |
|
•Each time you press the button, the input mode changes as follows:
ANALOG AUTO/PCM
(Digital)
DTS DOLBY DIGITAL
(Digital)(Digital)
Normally select “AUTO/PCM,” so the receiver automatically detects the incoming digital signal format. (The DIGITAL AUTO indicator lights up on the display.)
–When the receiver can recognize the digital signal format coming into the receiver, the frame of the digital signal indicator for the detected signal lights up automatically.
–When the receiver cannot recognize the incoming signal format correctly, the frame of the digital signal indicator flashes.
If this happens, select the same digital input mode with the incoming digital signal — either “DOLBY DIGITAL” or “DTS.”
To change the input mode back to analog input, select
“ANALOG.”
From the remote control: |
|
|
|
|
1. Press the source selecting button | DVD | DVD MUILTI | CD | TAPE/MD |
(CD, TAPE/MD, TV/DBS, DVD, | TV/DBS | VIDEO | PHONO | FM/AM |
or CDR/VCR2)* for which you | VCR 1 | CDR/VCR 2 |
|
|
want to change the input mode. |
|
|
|
|
Note:
*Among the sources listed above, you can select the digital input only for the sources which you have selected the digital input terminals for. (See “Digital Input (DIGITAL IN) Terminal Setting.”)
2. Press ANALOG/DIGITAL to | ANALOG/DIGITAL |
change the input mode. |
|
•Each time you press the button, the input mode changes as follows:
ANALOG AUTO/PCM
(Digital)
DTS DOLBY DIGITAL
(Digital)(Digital)
Notes:
•Noise may come out of the speakers while searching or skipping a
•When you change the source, the digital input mode will be automatically reset to “AUTO/PCM.”
Showing the Text Information on the
Display
When you have connected an MD recorder or CD player equipped with TEXT COMPU LINK remote control system (see page 39), you can show the text information, such as disc title or track title, on the display of this receiver. To show it on the display, follow the procedure below.
Before you start, remember....
•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
On the front panel only:
SETTING
1.Press SETTING repeatedly until “FL DISPLAY” appears on the
display.
The display changes to show the current setting.
2. Turn MULTI JOG to select either | MULTI JOG |
the source name or the text |
|
information to be shown on the |
|
display. |
|
•As you turn it, the display changes to show the following:
NORMAL TEXT
NORMAL: Source name appears during play.
TEXT: Text information appears during play.
Note:
Though you have selected “TEXT,” the source name such as “CD” or “MD” appears if a playing disc has no text information.
17