JVC rx-8010vbk manual Remove the obstruction

PROBLEM POSSIBLE CAUSE SOLUTION

“OVERLOAD” starts flashing on the display.

Speakers are overloaded because of high volume.

1.Press POWER on the front panel to turn off the receiver.

2.Stop the playback source.

3.Turn on the receiver again, and adjust the volume.

Speakers are overloaded because of short circuit of speaker terminals.

Press POWER on the front panel, then check the speaker wiring.

If “OVERLOAD” does not disappear, unplug the AC power cord, then plug it back again.

If speaker wiring is not short-circuited, contact your dealer.

The STANDBY lamp lights up after turning on the power, but soon the receiver turns off again (into standby mode).

The receiver is overloaded because of a high voltage.

Press POWER on the front panel to turn off the receiver. After unplugging the AC power cord, consult your dealer.

Remote control does not work.

There is an obstruction in front of the	Remove the obstruction.
remote sensor on the receiver.

Batteries are weak. Replace batteries. (See page 10.)

Remote control does not work intendedly.

An incorrect remote control operation mode is selected.

Select the correct remote control operation mode. (See page 52.)

56