JVC rx-8010vbk Center tone level you want for, CH Stereo mode only, Adjusting the 3D-PHONIC Modes

4.	Press LEVEL +/– to adjust the	+∗BAL L
	speaker output levels (–10 dB to	CH/∗LEVEL
	+10 dB).
		−∗BAL R
5.	Press SOUND.	SOUND
	• To adjust other speaker output levels, repeat
	steps 3 and 4.
6.	Press CTR TONE to select the	CTRTONE
	center tone level you want — for	5
		ENTER

5 CH Stereo mode only.

The center tone adjustment affects the mid- frequency range, which the human voice is mostly made up of.

•Each time you press the button, the display changes to show the following:

CTR TONE 1 CTR TONE 2 CTR TONE 3

(Softer)(Soft)(Flat)

CTR TONE 5	CTR TONE 4
(Sharper)	(Sharp)

To make the dialogue softer, select “CTR TONE 1” or “CTR

TONE 2.”

To make the dialogue clearer, select “CTR TONE 3” or “CTR

TONE 4.”

When “CTR TONE 3” is selected, no adjustment is applied.

Adjusting the 3D-PHONIC Modes

Before you start, remember...

•Make sure that you have set the speaker information correctly (see page 17).

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 2 again.

•You cannot adjust the center speaker output level when you have set “CTR SPK” to “NONE” See page 17.

•To adjust the front speaker output balance and subwoofer output level, see pages 16 and 17.

On the front panel:

1. Press DSP MODE repeatedly until DSP MODE

“3D ACTION” or “3D DIGITAL” appears on the display.

The DSP MODE lamp on the front panel

button lights up, and the 3D-PHONIC and DSP indicators also light up on the display.

2. Adjust the center speaker output level.

1)	Press LEVEL ADJUST repeatedly		L	LEVEL
				ADJUST
	until “CENTER” appears on the
	display.
2)	Press CONTROL UP 5/DOWN °to		CONTROL
	adjust the center speaker output level
		DOWN UP

(from –10 dB to +10 dB).

3. Adjust the center tone.

1)Press EFFECT repeatedly until “CTR TONE” appears on the display.

The display shows the current setting.

2)Press CONTROL UP 5/DOWN ° to select the center tone level you want.

•Each time you press the button, the display changes to show the following:

EFFECT SETT

CONTROL

DOWN UP

CTR TONE 1 CTR TONE 2 CTR TONE 3

(Softer)(Soft)(Flat)

CTR TONE 5	CTR TONE 4
(Sharper)	(Sharp)

To make the dialogue softer, select “CTR TONE 1” or

“CTR TONE 2.”

To make the dialogue clearer, select “CTR TONE 4” or

“CTR TONE 5.”

When “CTR TONE 3” is selected, no adjustment is applied.

33