20
To obtain the best possible sound effect from Surround/DSP
modes (see pages 33 to 37), you need to set up the speaker and
subwoofer information after all the connections are completed.
From pages 20 to 26, how to set speakers and other basic items
of the receiver are explained.

Setting the speaker information

easily—Quick Speaker Setup

Quick Speaker Setup helps you to easily and quickly register the
speaker size, speaker distance, and output level of each speaker
according to your listening room to create the best possible
surround effect.
•You can also register each speaker’s information manually.
For details, see pages 22, 23, and 28.
Menu operation buttons
On the front panel:
From the remote control:
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step
1
again.
In this section, the operation of the remote control is used for
explaining.
1
Press SETTING and press 5 / ∞ button
repeatedly until “QUICK SPK SET” appears on
the display.
•On the front panel, press SETTING and turn MULTI JOG.
2
Press SET.

Basic settings

3
Press 2 / 3 button repeatedly to select an
appropriate number of the connected
speakers (speaker channel number).
As you press 2 / 3 button, the speaker channel number
changes as follows.
•On the front panel, turn MULTI JOG.
•For the details of speaker channel number, see “ Speakers
(channels) number and the size” on page 21.
* “7.0ch” is the initial setting.
4
Press SET.
5
Press 2 / 3 button repeatedly to select an
appropriate room size to match to your
listening room.
As you press 2 / 3 button, the room size changes as follows:
•On the front panel, turn MULTI JOG.
•To select your appropriate room size, see “Room size and
the speaker distance/output level” on page 21.
*“L” is the initial setting.
6
Press SET.
QUICK SPEAKER SETUP is now completed, then the display
goes back to the previous setting item.
7
Press EXIT.
•On the front panel, press SETTING.
NOTES
•This procedure will not be completed if you stop in the middle of
the setting process.
•Once Quick Speaker Setup is performed, the speaker output
levels are also set to appropriate values automatically (common
to all sources). If you want to set the speaker output levels
separately for each source, see “Adjusting the speaker output
levels” on page 28.
L
S.WFR
R
ANALOG
L
S.WFR
R
ANALOG
L
S.WFR
R
ANALOG
L
S.WFR
R
ANALOG
3.1ch
4.0ch
6.0ch 6.1ch
4.1ch
2.0ch 2.1ch
5.0ch 5.1ch
7.0ch* 7.1ch
3.0ch
(Back to the beginning)
L
S.WFR
R
ANALOG
(Back to the beginning)
SML*

1,7 2,4,6 1,3,5

1
7
1
(5
/
∞button)
2,4,6
(SET button)
3,5
(2
/
3button)
20-26RX-D401S[J]_f.p65 05.7.1, 7:07 PM20