JVC RX-E11S manual Connecting the speakers, Connecting the subwoofer, Getting started

Getting started

Connecting the speakers

Speaker Layout Diagram
			Left front		Right front
			speaker (L)		speaker (R)
					Subwoofer (SW)
			Center speaker (C)
	Left surround						Right surround
	speaker (LS)						speaker (RS)
1	2	3	3(VCR)	2(DBS)	1(DVR/DVD)		CAUTION:SPEAKER
	2	1					IMPEDANCE 6	- 16
					FRONT	CENTER	SURROUND
								SPEAKERS
					RIGHT LEFT		RIGHT LEFT
			VIDEO	DIGITAL IN

SUBWOOFER

OUT

MONITOR S-

OUT

SW R L C RS LS

Connecting the front, center, and surround speakers	Connecting the subwoofer
	By connecting a subwoofer, you can enhance the bass or
Turn off all components before making connections.
	reproduce the original LFE signals recorded in digital software.

1Twist and remove the insulation at the end of each speaker cord.

2Press and hold the clamp of the speaker terminal (1), then insert the speaker cord (2).

•For each speaker, connect the (+) and (–) terminals on the rear panel to the (+) and (–) terminals marked on the speakers.

3Release the finger from the clamp.

CAUTIONS:

•Use speakers with the SPEAKER IMPEDANCE indicated by the speaker terminals (6 Ω – 16 Ω).

•DO NOT connect more than one speaker to one speaker terminal.

Connect the input jack of a powered subwoofer to the SUBWOOFER OUT jack on the rear panel, using a cord with RCA pin plugs (not supplied).

•Refer also to the manual supplied with your subwoofer.

After connecting all the speakers and/or a subwoofer, set the speaker setting information properly to obtain the best possible surround effect. For details, see pages 14 to 17.

NOTE

You can place a subwoofer wherever you like since bass sound is non-directional. Normally place it in front of you.

6