JVC RX-F10S manual Basic settings

English

Basic settings

To obtain the best possible sound effect from Surround/DSP modes (see pages 27 to 31), you need to set up the speaker and subwoofer information after all the connections are completed. From pages 16 to 21, how to set speakers and other basic items of the receiver are explained.

2Press and hold SMART SURROUND SETUP until “SETTING UP” flashes on the display.

EQ C.TONE		VIRTUAL SB AUDIO P. BASS			TA NEWS INFO RDS TUNED ST AUTO MUTING SLEEP AUTO MODE
LPCM	L	C	R	PL	ATT
DOLBY D	S . WFR LFE			NEO : 6	HP
DTS AAC				DSP 3D	MHz
	LS	SB	RS
96 / 24				AUTO SR	kHz

3Confirm that “SETTING UP” stops flashing, then clap your hands over your head once while “SETTING UP” still remains on the display.

The receiver starts detecting the level of the sound coming

through each speakers (except the subwoofer).

Basic settings

Setting the speaker information automatically—Smart Surround Setup

The distance from your listening point to the speakers is one of the important elements to obtain the best possible sound effect for the Surround/DSP modes.

By using Smart Surround Setup, the following are automatically calculated by one simple action—clapping hands.

•Speaker distance (compared to that of the closest speaker)

•Speaker output level (except the subwoofer)

		When your clapping sound is detected successfully,
	NOTES	“SUCCESSFUL” appears on the display, then the values set are
•	To set the speaker information effectively using Smart Surround	shown as follows:
		Ex.:	*1	*2	*3	*4
	Setup, unplug the power cords of all the components connected
	to this receiver and the subwoofer which may cause noise.
•	Before starting Smart Surround Setup, set the speaker
	information correctly (SML, LRG, or NO) according to your
	speakers except the subwoofer (see page 18).			L	R	C
• When the setting is made by Smart Surround Setup, the
	speaker distance and output level you have set before will be			LS	RS	SB
	inactive.
•	If you have turned off the display, cancel the Dimmer (see page
	15); otherwise, you cannot see the information on the display			Then the receiver returns to
	during Smart Surround Setup.			normal operation mode.
•	Smart Surround Setup will not be done correctly if you or other
	object blocks the sound.	*1 Standard channel (the closest speaker).
• When you change your speakers, do the following procedure			This speaker position now works as the reference
	again.		position (“0m/ft”) and other speakers’ distance is
From the remote control ONLY:			shown by the difference with this reference speaker
			position.
		*2	L:	Left front speaker
	When operating the receiver		R:	Right front speaker
			C:	Center speaker
	using the remote control, set
			LS: Left surround speaker
	the mode selector to
			RS: Right surround speaker
	“AUDIO/TV/VCR/DBS.”
			SB: Surround back speaker
		*3 Difference of each speaker position in distance (in
			meters or feet).
		*4 Each speaker’s output level (–6 to +6).

1Take your position where you listen to the

sound.	When your clapping sound is not detected correctly,
	“SETTING UP” appears again after one of the following
• Make sure speaker cables are connected firmly.
	messages. In this case, repeat step 3.

SILENT: • The receiver detects sound from only the left and right front speakers.

• The receiver detects no sound from the front speakers and detects sound from at least one of the other speakers.

SILENT-ALL:The receiver cannot detect any sound from any

speakers for about 15 seconds.

FAILED: The receiver cannot detect sound from the left or right front speaker.

16