Before using this System

Precautions

There are no user-serviceable parts inside. If anything goes wrong, unplug the power cord and consult your dealer.

Notes on installing the System

Select a location which is level, dry and neither too hot nor too cold between 5°C and 35°C.

Do not install the System in a location subject to vibrations.

Do not put heavy objects on the System.

Avoid moisture, water, dust, and high temperatures

Do not install the System in moist or dusty locations.

If water gets inside the System, turn off the power and remove the plug from the wall outlet, then consult your dealer. Using the System in this state may cause a fire or electrical shock.

Do not expose the System to direct sunlight or place it near a heating device.

To prevent malfunctions or damage to the System

Do not insert any metallic objects, such as wires, hairpins, coins, etc. into the System.

Do not block the vents.

Notes on the power cord

When you are away on travel or otherwise for an extended period of time, remove the plug from the wall outlet. A small amount of power is always consumed while the power cord is connected to the wall outlet.

When unplugging the System from the wall outlet, always pull the plug, not the power cord.

Disconnect the power cord before cleaning or moving the System.

Do not modify, twist or pull the power cord, or put anything heavy on it. Doing so may cause fire, electric shock, or other accidents.

About copyright laws

Observe the copyright laws in your country before recording from original sources. Recording of copyrighted material may infringe copyright laws.

About the copyguard system

The discs are protected by the copyguard system. When connecting the System to a TV via a VCR, or to a TV with a built-in VCR, the copyguard system activates and distortion of the picture may occur.

Notes on installing and using the speakers

Place the speakers and subwoofer on a flat and level surface.

The speakers are magnetically shielded to avoid color distortions on TVs. If the color on a TV is distorted, perform the following procedure:

Turn off the TV’s main power switch or unplug it before installing the speakers. Then wait at least

30 minutes before turning on the TV’s main power

switch again.

Some TVs may still be affected even though you have followed the above procedure. If this happens, move the speakers away from the TV.

The subwoofer is not magnetically shielded. To avoid color distortion, do not place it near the TV or monitor.

When moving the speakers and subwoofer, do not pull the speaker cords. Doing so may cause the speakers and/or subwoofer to fall over, causing damage or injury.

When installing the speakers on a wall, be sure to have them installed by qualified personnel. DO NOT install the speakers on a wall by yourself.

Do not lean against the speakers, as they could fall down or break, possibly causing an injury. Be especially careful that children do not lean against them.

About the adjustment of volume

Always set the volume to the minimum level before starting any source. If the volume is set at a high level, the sudden blast of sound could permanently damage your hearing and/ or blow out the speakers.

To clean the System

Use a soft cloth. Follow the relevant instructions on the use of chemically-coated cloths.

If the System is heavily stained, apply a small amount of water or neutral detergent to the cloth and wipe clean, then wipe with a dry cloth.

Do not use benzene, thinner or other organic solvents and disinfectants. These may cause deformation or discoloring.

2