Types of speaker systems

JVC

JVC

SP-XE5F/SP-XE51F

SP-XE5S/SP-XE51S

Front/Center speaker (3)

Surround speaker (2)

Connection

1.If cords are covered with insulation, twist the core of the cord at the end of each cord, then remove the insulation.

2.Insert it into the hole while pressing down the terminal lever. Observe the tag attached to each cord, and use the appropriate cord for each speaker.

For SP-XE5F/SP-XE51F (Rear)

Black · Red ª

Black striped Copper

For SP-XE5S/SP-XE51S (Bottom)

Black · Red ª

Black striped Copper

Through the hole

3. Connect to the amplifier.

SP-XE5F/SP-XE51F SP-XE5F/SP-XE51F SP-XE5F/SP-XE51F

 

CENTER

FRONT

FRONT

RIGHT

LEFT

Speaker terminals on the amplifier

SURROUND

SURROUND

RIGHT

LEFT

SP-XE5S/SP-XE51S

SP-XE5S/SP-XE51S

ENGLISH

Precautions

Before connecting:

Make sure to match the polarity (ª and ·) when connecting the speaker cords.

Turn off the power to the amplifier before connecting the speaker system; otherwise, the speakers may be damaged.

The impedance of each speaker is 6 .

If this does not match with the speaker impedance range indicated on the amplifier, you cannot connect this system to the amplifier.

The maximum power handling capacity of the SP-XE5/SP-XE51 is 50 W. Excessive input will result in abnormal noise and possible damage.

Daily operations and maintenance:

Be sure to turn down the volume level on the amplifier to prevent unwanted noise before performing following operations:

Turning on or off other components

Operating the amplifier

Tuning FM stations

Fast-forwarding a tape

Continuously reproducing high frequency oscillation or high pitch electronic sounds

Connecting or disconnecting a microphone

When using a microphone, do not aim it at the speakers or use it near the speakers; otherwise, the howling which occurs may damage the speakers.

Before replacing the cartridge, always turn off the power both to the amplifier and to the turntable; otherwise, the clicking noise may damage the speakers.

Caution

When installing the satellite speakers on the wall;

Be sure to have them installed on the wall by a qualified personnel. DO NOT install the satellite speakers on the wall by yourself to avoid unexpected damage from their falling off the wall due to incorrect installation or weakness in wall structure.

Care must be taken in selecting a location for speaker installation on a wall. Injury to personnel or damage to equipment may result if the speakers installed interfere with daily activities.

Speaker for A/V combination

SP-XE5/SP-XE51 has a magnetically-shielded design for placement adjacent to TVs and monitors without causing color aberrations. However, color may be affected as a result of how the speaker system is installed. Therefore, be careful of the following:

1.When placing these speakers near a TV set, turn off the TV’s main power switch or unplug it before installing the speakers.

Wait at least 30 minutes after the system is installed before turning on the TV’s power.

2.If another speaker system has been set up near the TV set, that system may cause color unevenness in the TV’s picture.

3.In spite of the shielded design of these speakers, some types of TVs may be affected by them. If this happens, move the speakers a short distance from the TV set.

Specifications

SP-XE5F/SP-XE51F (FRONT/CENTER SPEAKER)

Type

: 1-way bass-reflex type

 

(Magnetically-shielded type)

Speakers

: 8 cm cone

Power handling capacity

: 50 W

Impedance

: 6

Frequency range

: 90 Hz – 20 000 Hz

Sound pressure level

: 83 dB/W·m

Dimensions (W H D) : 106 mm 119.5 mm 102 mm

Mass

: 0.64 kg each

Accessories

: Speaker cords (4 m) ... 3

SP-XE5S/SP-XE51S (SURROUND SPEAKER)

Type

: 1-way bass-reflex type

 

(Magnetically-shielded type)

Speakers

: 8 cm cone

Power handling capacity

: 50 W

Impedance

: 6

Frequency range

: 80 Hz – 20 000 Hz

Sound pressure level

: 76 dB/W·m

Dimensions (W H D) : 111.5 mm 139 mm 106.5 mm

Mass

: 0.52 kg each

Accessories

: Speaker cords (10 m) ... 2

Design and specifications subject to change without notice.

– 3 –