JVC SP-XSA75 DVD Playback FM/AM, Problem, Possible Cause, Solution, screen, audio language, noise

PROBLEM		POSSIBLE CAUSE	SOLUTION
No picture is displayed on the TV	The video cord or SCART cable is not		Connect the cord correctly.
screen.	connected correctly.		(See page 7.)
	The RGB-Y/C selector is not set correctly. Select the correct mode. (See page
			7.)
	Incorrect TV input mode is selected.		Select the correct input mode on
			the TV.
A disc cannot be played.	The disc is not playable.		Use a playable disc. (See page 5.)
	The disc Region Code numbers are		Replace the disc. (See page 5.)
	incompatible.
	Playback is restricted by Parental Lock.		Enter password to change the
			Parental Lock level. (See page 62.)
A disc cannot be played and “0:00” is	The disc is loaded with its label and data		Load the disc correctly. (See page
displayed on the display window.	sides inverted.		20.)
	An unplayable disc is inserted.		Replace the disc. (See page 5.)
Video and audio are distorted.	The disc is scratched or dirty.		Replace or clean the disc. (See
			page 65.)
	A VCR is connected between the center		Connect the center unit and TV
	unit and the TV.		directly.
	“STILL MODE” may not be set		Change “STILL MODE.” (See page
	appropriately for the current disc.		57.)
The picture does not fit the TV screen.	“MONITOR TYPE” is not set correctly.		Set the monitor type correctly. (See
			page 57.)
	The TV is not set correctly.		Set the TV correctly.
No subtitle appears on the TV screen			Some DVDs are programmed to
though you have selected as your			always display no subtitle initially. If
initial subtitle language.			this happens, press SUBTITLE on
			the remote control after starting
			play. (See page 41.)
Audio language is different from the			Some DVDs are programmed to
one you have selected as your initial			always use the original language
audio language.			initially. If this happens, press
			AUDIO on the remote control after
			starting play. (See page 41.)
Hard to listen to broadcast because of	Antennas are disconnected.		Reconnect the antennas correctly
noise.			and securely.
—For AM (MW)	The AM (MW) loop antenna is too close		Change the position and direction
	to the center unit.		of the AM (MW) loop antenna.
	Beat Cut mode is not set properly.		Try to change the Beat Cut mode.
			(See page 23.)
—For FM	The supplied FM antenna is not properly		Extend the FM antenna at the best
	extended and positioned.		position.
Continuous static during FM	The received signal is too weak.		Connect an external FM antenna
broadcasts.			(see page 9), or contact your
			dealer.
	The station is too far away.		Select another station.
	An incorrect antenna is used.		Check with your dealer to be sure
			you have a correct antenna.

DVD Playback

FM/AM

67