Connections
Do not connect the power cord until all other connections have been made.
7Connecting the satellite speakers to the subwoofer
Note that the illustration below is for
Before connecting the speaker cords;
Twist and pull the insulation coat off and remove.
Powered subwoofer |
Center speaker
Front speakers
Speaker cord
•Connect the black cords to the black (r) terminals.
•Connect the white cords to the (q) terminals referring to the table below:
FRONT SPEAKERS (LEFT) | White |
|
|
FRONT SPEAKERS (RIGHT) | Red |
|
|
CENTER SPEAKER | Green |
|
|
SURROUND SPEAKERS (LEFT) | Blue |
|
|
SURROUND SPEAKERS (RIGHT) | Gray |
|
|
Surround speakers
CAUTION
•If you connect speakers other than the supplied ones, use speakers of the same speaker impedance (SPEAKER IMPEDANCE) indicated near the speaker terminals on the rear of the powered subwoofer.
•DO NOT connect more than one speaker to one speaker terminal.
•When installing the satellite speakers on the wall;
–Be sure to have them installed on the wall by qualified personnel. DO NOT install the satellite speakers on the wall by yourself to avoid unexpected damage from falling off the wall due to incorrect installation or weakness in wall structure.
–Care must be taken in selecting a location for speaker installation on a wall. Injury to personnel or damage to equipment may result if the speakers installed interfere with daily activities.
Precautions for daily use
•When moving the speakers, do not pull the speaker cords; otherwise, the speakers may fall over, causing damage or injury.
•Do not reproduce sounds at so high a volume that the sound is distorted; otherwise, the speakers may be damaged by internal heat buildup.
For
•When holding a speaker, always grasp the lower portion.
•Do not lean against the speakers, as the speakers could fall down or break, possibly causing an injury. Especially be careful that children do not lean against them.
11
