Basic operations
Changing the decode mode
When you play a disc (or software) encoded with Dolby Digital or
DTS Digital Surround, the following symptoms may occur;
•Sound does not come out at the beginning of playback.
•Noise comes out while searching for or skipping chapters or tracks.
In these cases, change the decode mode to “DOLBY D” (for Dolby
Digital) or “DTS” (for DTS Digital Surround).
%When DVD or DBS is selected as the source
On the remote control:
Press DECODE to select the decode mode.
The current decode mode appears on the display window.
Example: When “AUTO/PCM” is selected.
Each time you press the button, the decode mode changes as follows;
] AUTO/PCM | ] DOLBY D | ] DTS ] (back to the |
beginning) |
|
|
•AUTO/PCM: Normally select this. The system automatically detects the incoming signals.
•DOLBY D: Select this if the symptoms above occur when
playing a disc (or software) encoded with Dolby Digital.
• DTS: Select this if the symptoms above occur when playing a disc (or software) encoded with DTS Digital Surround.
NOTE
•When “DOLBY D” or “DTS” is selected, if a signal encoded with another digital format comes in, you cannot listen to the sound. (The /DIGITAL or + indicator flashes.)
•Changing the source returns the decode mode to “AUTO/PCM” automatically.
Changing the scan mode
This system supports the progressive scan system (480p*) as well as the conventional interlaced scan system (480i*).
If your TV equipped with component jacks supports the progressive video input, you can enjoy a high quality picture by setting the progressive scan mode to active.
•Refer also to the instruction manuals supplied with your TV.
•If your TV equipped with component jacks does not support the progressive video input, do not change the scan mode to the progressive scan mode.
*480p and 480i indicate the number of scanning lines and scanning format of an image signal.
•480p indicates 480 scanning lines with progressive format.
•480i indicates 480 scanning lines with interlaced format.
%When DVD is selected as the source
On the remote control:
1Press DVD.
2Press and hold PROGRESSIVE for
3 seconds.
Each time you perform this operation, the scan mode changes as follows;
INTERLACE | O PROGRESSIVE |
•INTERLACE: Select this if your TV equipped with component jacks supports the interlaced video input only.
•PROGRESSIVE:Select this if your TV equipped with
component jacks supports the progressive video input.
When “PROGRESSIVE” is selected, the PROGRESSIVE indicator lights.
NOTE
•There are some progressive TVs and
To check the compatibility of your TV, contact your local JVC customer service center.
•All JVC progressive TVs and
22
