Getting started
4 Press number buttons
| the manufacturer’s code (2 digits). | |||
| Examples: | 1 , then | 0 . |
|
Remote control | For a Hitachi TV: Press |
| ||
For a Toshiba TV:Press | 0 , then | 8. |
| |
mode selector |
| |||
|
|
|
| |
| Manufacturer | Code Manufacturer | Code | |
| JVC | 01 | Samsung | 12 |
| Hitachi | 10 | Sanyo | 13 |
| Magnavox | 02 | Sharp | 06 |
(play button) | Mitsubishi | 03 | Sony | 07 |
| Panasonic | 04, 11 | Toshiba | 08 |
| RCA | 05 | Zenith | 09 |
| 5 Release F TV. |
|
| |
| 6 Try operating your TV by pressing |
| ||
| F TV. |
|
|
|
Number 
buttons
When your TV turns on or off, you have entered the correct code.
If there is more than one code listed for corresponding brand, try each one until you enter the correct one.
NOTE
•Manufacturers’ codes are subject to change without notice. If they are changed, this remote control cannot operate the equipment.
•Set the codes again after replacing the batteries of the remote control.
For TV operations
You can operate your TV using the remote control supplied with this system.
• Refer also to the instruction manuals supplied with your TV.
7To set the manufacturer’s code
7Operation
IMPORTANT |
|
|
| |
Before using the remote control to operate a |
| |||
TV; |
|
|
| TV . |
• Set the remote control mode selector to | ||||
The following buttons are available: |
|
|
| |
.TV : |
| Turns TV on and off. |
| |
TV VOL +/– | : | Adjusts the volume. |
| |
TV/VIDEO | : | Selects the input mode (either TV or | ||
|
| VIDEO). |
| |
CHANNEL | Changes the channels. |
| ||
| ||||
TV RETURN | : | Alternates between the previously selected | ||
|
| channel and the current channel. | ||
For DBS tuner or CATV converter operations
You can operate a JVC TV without setting the remote control signal.
1Slide the remote control mode selector to TV.
2 Press and hold F TV.
Keep the button pressed until step 4 is finished.
3Press ENTER.
You can operate your DBS tuner or CATV converter using the remote control supplied with this system.
•Refer also to the instruction manuals supplied with your DBS tuner or CATV converter.
7To set the manufacturer’s code
1Slide the remote control mode selector to VCR/DBS.
2Press and hold DBS.
Keep the button pressed until step 4 is finished.
3Press ENTER.
17
