Introduction

Names and Operations of Parts (continued)

Body Underside

3

4

21

4

Main unit side

5

7

6

7

1Power Supply cable

To input DC 12 V or AC 24 V power.

The AC 24 V power supply should conform to the following:

U-type: Class 2 only

E-type: Isolated power supply only

2Video signal output connector (BNC)

This BNC connector outputs a composite video signal. Connect this to the video input connector of a video monitor, switcher, etc.

3Safety cable

This wire is mounted to the ceiling slab or channel. (Safety cable not included.)

CAUTION:

To avoid unforeseen accidents, attach the safety cable. Otherwise, there is nothing to prevent the camera from falling should it come loose.

4Mounting holes

These holes are used to mount the camera body to the ceiling. When using a 4 inch square electrical box, the 2 holes diagonally across are used to fix the box in place.

(  page 13)

5Cable extraction hole

This hole is used to extract cables from the side of the camera without opening holes in the ceiling.

6Cover

This cover is removed to pull the cables through the 5 cable extraction hole. Replace the cover after pulling the cables.

7Cover locking screw

This screw is removed when removing the 6 cover.

E-8

Page 10
Image 10
JVC TK-C205 manual  Body Underside