110 Dual Fuel
Installation Instructions
User Guide
U108600-07
Contents
surfaces To avoid overheating, DO NOT install the cooker
1. Before You Start
WARNING The appliance and its accessible parts
nnDO NOT use a steam cleaner to clean the cooker
and ammable liquids a safe distance away from your cooker
nnThis appliance is heavy so take care when moving it
Always keep combustible materials, e.g. curtains
DO NOT store ammable materials in the storage
Fig.2-1
2. Cooker Overview
Hotplate Burners
B C E D F
Page
DO NOT put it on any other burner - it is not
DO NOT put it crossways - it will not t properly and
will be unstable Fig.2-12
designed to t in any of the other pan supports
Fig.2-15 Fig.2-16
nnNever close the grill door when the grill is on
ArtNo.210-0001 Classic grill control
Use only heat resistant dishes
The Browning Element
The Ovens
Operating the Ovens
The Conventional Oven
Minute Minder
Setting the Time of Day
B C D
To Stop the Ovens Automatically
Fig.2-31
AUTO is Showing, You Want to Reset to Manual Cooking
Key Lock
Fig.2-36
Oven Shelves
The Handyrack Main Oven
Fig.2-39 Fig.2-40
DO NOT use the timed oven if the adjoining oven is
Tips on Cooking with the Timer
General Oven Tips
already warm
4. Cooking Table
The Single Ring Burners
5. Cleaning Your Cooker
DO NOT mix dierent cleaning products - they may
The Wok Burner
DO NOT use harsh abrasive cleaners or sharp metal
‘Cook & Clean’ Panels
Before you remove any of the grill parts for cleaning
DO NOT use steel wool, oven cleaning pads, or any
Hotplate
Cleaning Table
Removing the Main Oven Linings
Outside of Cooker
What cleaning materials are recommended for the cooker?
6. Troubleshooting
Hotplate ignition or hotplate burners faulty
Never use caustic or abrasive cleaners as these will
Fig.6-1 Fig.6-2
An oven light is not working
The oven door is misaligned
Out of Warranty
7. Installation
If You Have a Problem
Please Note
INSTALLATION
Installer’s Name Installer’s Company
Installer’s Telephone Number
Before installation, make sure that the local
Checking the Parts
INSTALLATION
You will also need the following tools
2. Side Clearances - Measurements B & C
INSTALLATION
1. Overhead - Measurement A
3. Side Clearances - Measurement D & E
Completing the Move
INSTALLATION
Lowering the Two Rear Rollers
Fig.7-3 Fig.7-4 Fig.7-5
Fitting a Stability Bracket
INSTALLATION
Fitting the Stability Bracket and Chain
Fitting the Restraining Chain
Classic only
INSTALLATION
Fig.7-10 Fig.7-11
nnThe handles should be above the xings
Propane
INSTALLATION
Natural Gas
600Fig.7-12
IF IN DOUBT, PLEASE CONTACT A SUITABLY QUALIFIED ELECTRICIAN
Fixed Wiring
Current Operated Earth Leakage Breakers
nnWARNING THIS APPLIANCE MUST BE EARTHED
Customer Care
Final Checks
Fitting the Plinth
Hotplate Check
When servicing or replacing gas-carrying
8. Conversion to LP Gas
invalidate any warranty or liability claims and lead to prosecution
Classic - Removing the Control Panel
Page
1.2 To Remove the Side Panels
9. Servicing
1.1 To Remove the Control Panel
2.1 To Remove the Hotplate
2.6 To Change the Warmer Neon
3.1. To Replace the Ignition or Light Switch
2.5 To Replace a Hotplate Burner
2.2 To Replace the Hotplate Control Taps
3.4 To Change the Ignition Generator
3.3 To Change the Warmer Switch
3.2 To Replace the Clock
4.1 To Replace the Grill Controller
5.3 To Change the Fan in the Right-hand Oven
5.1 To Replace a Thermostat
5.2 To Remove the Right-hand Oven Inner Back
5.4 To Remove an Oven Element Thermal Cut-out
Bottom Element
5.5 To Remove the Right-hand Oven Element
5.6 To Remove the Left-hand Oven Bottom and Top Elements
Top Element
6.2 To Replace an Oven Door
6.3 To Adjust an Oven Door Angle
6.6 To Adjust an Oven Door Catch Keep
6.4 To Replace an Oven Door Outer Panel
Description
10. Circuit Diagram
Description
Colour
Usable volume litres
11. Technical Data
Maximum power output @ 230V 50 Hz
COUNTRY OF DESTINATION Australia
E-mail consumers@falconappliances.co.uk
Clarence Street, Royal Leamington Spa Warwickshire, CV31 2AD, England
Tel +44 0 1926 457400 Fax +44