WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have nished.
9. Servicing
Fig.9-1
Art No
Fig.9-2
A 
B 
C
A – Flue grill, B – Cooker backsheet, C – Earthing/xing screws
Fig.9-3
A 
B 
C
A – Flue grill, B – Cooker backsheet, C – Earthing/xing screws
BEFORE SERVICING ANY GAS CARRYING
nn
COMPONENTS TURN OFF THE GAS SUPPLY
Check the appliance is gas sound after completion
nn
of service. When checking for gas leaks DO NOT use washing up liquid – this can corrode. Use a product specically manufactured for leak detection.
DO NOT use reconditioned or unauthorised gas
nn
controls.
Disconnect from the electricity supply before
nn
servicing, particularly before removing any of the following: control panel, side panels, hotplate tray or any electrical components or covers.
Before electrical reconnection, check that the
nn
appliance is electrically safe.
1 Panels
1.1To Remove the Control Panel
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Classic – Removing the Control Panel
Remove the handrail. Now remove the 2
Pull o all the control knobs and remove the xing screws underneath the control panel.
Lift the control panel and pull forwards, taking care not to damage or strain the wiring.
Toledo – Removing the Control Panel
Pull o all the control knobs and remove the xing screws underneath the control panel.
Slide the control panel to the right and then pull forwards, taking care not to damage or strain the wiring.
1.2To Remove the Side Panels
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Remove the control panel (see 1). Pull the cooker forward. Remove the 4 retaining screws for each panel (1 at the front base, 1 on the top and 2 at the rear). Reassemble in the reverse order.
2 Hotplate
BEFORE SERVICING ANY GAS CARRYING
nn
COMPONENTS, TURN OFF THE GAS SUPPLY.
2.1To Remove the Hotplate
Pull the cooker forward to gain access to the rear.
Left-hand tray
From the rear remove the screws securing the ue grill to the hotplate tray. Remove pan supports, burner heads and caps. Remove the 4 screws and washers holding the hotplate tray to the frame. Raise the front of the hotplate then withdraw.
30
