Installation Instructions
User Guide
110 Dual Fuel
U108600-07
Contents
1. Before You Start
WARNING The appliance and its accessible parts
surfaces To avoid overheating, DO NOT install the cooker
nnDO NOT use a steam cleaner to clean the cooker
nnThis appliance is heavy so take care when moving it
Always keep combustible materials, e.g. curtains
and ammable liquids a safe distance away from your cooker
DO NOT store ammable materials in the storage
2. Cooker Overview
Hotplate Burners
Fig.2-1
B C E D F
Page
DO NOT put it crossways - it will not t properly and
will be unstable Fig.2-12
DO NOT put it on any other burner - it is not
designed to t in any of the other pan supports
nnNever close the grill door when the grill is on
ArtNo.210-0001 Classic grill control
Fig.2-15 Fig.2-16
Use only heat resistant dishes
The Ovens
Operating the Ovens
The Browning Element
The Conventional Oven
Setting the Time of Day
B C D
Minute Minder
To Stop the Ovens Automatically
Fig.2-31
AUTO is Showing, You Want to Reset to Manual Cooking
Key Lock
Oven Shelves
The Handyrack Main Oven
Fig.2-36
Fig.2-39 Fig.2-40
Tips on Cooking with the Timer
General Oven Tips
DO NOT use the timed oven if the adjoining oven is
already warm
4. Cooking Table
5. Cleaning Your Cooker
DO NOT mix dierent cleaning products - they may
The Single Ring Burners
The Wok Burner
‘Cook & Clean’ Panels
Before you remove any of the grill parts for cleaning
DO NOT use harsh abrasive cleaners or sharp metal
DO NOT use steel wool, oven cleaning pads, or any
Cleaning Table
Removing the Main Oven Linings
Hotplate
Outside of Cooker
6. Troubleshooting
Hotplate ignition or hotplate burners faulty
What cleaning materials are recommended for the cooker?
Never use caustic or abrasive cleaners as these will
Fig.6-1 Fig.6-2
An oven light is not working
The oven door is misaligned
7. Installation
If You Have a Problem
Out of Warranty
Please Note
Installer’s Name Installer’s Company
Installer’s Telephone Number
INSTALLATION
Before installation, make sure that the local
Checking the Parts
INSTALLATION
You will also need the following tools
INSTALLATION
1. Overhead - Measurement A
2. Side Clearances - Measurements B & C
3. Side Clearances - Measurement D & E
INSTALLATION
Lowering the Two Rear Rollers
Completing the Move
Fig.7-3 Fig.7-4 Fig.7-5
INSTALLATION
Fitting the Stability Bracket and Chain
Fitting a Stability Bracket
Fitting the Restraining Chain
INSTALLATION
Fig.7-10 Fig.7-11
Classic only
nnThe handles should be above the xings
INSTALLATION
Natural Gas
Propane
600Fig.7-12
Fixed Wiring
Current Operated Earth Leakage Breakers
IF IN DOUBT, PLEASE CONTACT A SUITABLY QUALIFIED ELECTRICIAN
nnWARNING THIS APPLIANCE MUST BE EARTHED
Final Checks
Fitting the Plinth
Customer Care
Hotplate Check
8. Conversion to LP Gas
invalidate any warranty or liability claims and lead to prosecution
When servicing or replacing gas-carrying
Classic - Removing the Control Panel
Page
9. Servicing
1.1 To Remove the Control Panel
1.2 To Remove the Side Panels
2.1 To Remove the Hotplate
3.1. To Replace the Ignition or Light Switch
2.5 To Replace a Hotplate Burner
2.6 To Change the Warmer Neon
2.2 To Replace the Hotplate Control Taps
3.3 To Change the Warmer Switch
3.2 To Replace the Clock
3.4 To Change the Ignition Generator
4.1 To Replace the Grill Controller
5.1 To Replace a Thermostat
5.2 To Remove the Right-hand Oven Inner Back
5.3 To Change the Fan in the Right-hand Oven
5.4 To Remove an Oven Element Thermal Cut-out
5.5 To Remove the Right-hand Oven Element
5.6 To Remove the Left-hand Oven Bottom and Top Elements
Bottom Element
Top Element
6.3 To Adjust an Oven Door Angle
6.6 To Adjust an Oven Door Catch Keep
6.2 To Replace an Oven Door
6.4 To Replace an Oven Door Outer Panel
10. Circuit Diagram
Description
Description
Colour
11. Technical Data
Maximum power output @ 230V 50 Hz
Usable volume litres
COUNTRY OF DESTINATION Australia
E-mail consumers@falconappliances.co.uk
Clarence Street, Royal Leamington Spa Warwickshire, CV31 2AD, England
Tel +44 0 1926 457400 Fax +44