User Guide
Installation Instructions
110 Dual Fuel
U108600-07
Contents
WARNING The appliance and its accessible parts
1. Before You Start
surfaces To avoid overheating, DO NOT install the cooker
nnDO NOT use a steam cleaner to clean the cooker
Always keep combustible materials, e.g. curtains
nnThis appliance is heavy so take care when moving it
and ammable liquids a safe distance away from your cooker
DO NOT store ammable materials in the storage
Hotplate Burners
2. Cooker Overview
Fig.2-1
B C E D F
Page
will be unstable Fig.2-12
DO NOT put it crossways - it will not t properly and
DO NOT put it on any other burner - it is not
designed to t in any of the other pan supports
ArtNo.210-0001 Classic grill control
nnNever close the grill door when the grill is on
Fig.2-15 Fig.2-16
Use only heat resistant dishes
Operating the Ovens
The Ovens
The Browning Element
The Conventional Oven
B C D
Setting the Time of Day
Minute Minder
To Stop the Ovens Automatically
Key Lock
AUTO is Showing, You Want to Reset to Manual Cooking
Fig.2-31
The Handyrack Main Oven
Oven Shelves
Fig.2-36
Fig.2-39 Fig.2-40
General Oven Tips
Tips on Cooking with the Timer
DO NOT use the timed oven if the adjoining oven is
already warm
4. Cooking Table
DO NOT mix dierent cleaning products - they may
5. Cleaning Your Cooker
The Single Ring Burners
The Wok Burner
Before you remove any of the grill parts for cleaning
‘Cook & Clean’ Panels
DO NOT use harsh abrasive cleaners or sharp metal
DO NOT use steel wool, oven cleaning pads, or any
Removing the Main Oven Linings
Cleaning Table
Hotplate
Outside of Cooker
Hotplate ignition or hotplate burners faulty
6. Troubleshooting
What cleaning materials are recommended for the cooker?
Never use caustic or abrasive cleaners as these will
The oven door is misaligned
An oven light is not working
Fig.6-1 Fig.6-2
If You Have a Problem
7. Installation
Out of Warranty
Please Note
Installer’s Telephone Number
Installer’s Name Installer’s Company
INSTALLATION
Before installation, make sure that the local
You will also need the following tools
INSTALLATION
Checking the Parts
1. Overhead - Measurement A
INSTALLATION
2. Side Clearances - Measurements B & C
3. Side Clearances - Measurement D & E
Lowering the Two Rear Rollers
INSTALLATION
Completing the Move
Fig.7-3 Fig.7-4 Fig.7-5
Fitting the Stability Bracket and Chain
INSTALLATION
Fitting a Stability Bracket
Fitting the Restraining Chain
Fig.7-10 Fig.7-11
INSTALLATION
Classic only
nnThe handles should be above the xings
Natural Gas
INSTALLATION
Propane
600Fig.7-12
Current Operated Earth Leakage Breakers
Fixed Wiring
IF IN DOUBT, PLEASE CONTACT A SUITABLY QUALIFIED ELECTRICIAN
nnWARNING THIS APPLIANCE MUST BE EARTHED
Fitting the Plinth
Final Checks
Customer Care
Hotplate Check
invalidate any warranty or liability claims and lead to prosecution
8. Conversion to LP Gas
When servicing or replacing gas-carrying
Classic - Removing the Control Panel
Page
1.1 To Remove the Control Panel
9. Servicing
1.2 To Remove the Side Panels
2.1 To Remove the Hotplate
2.5 To Replace a Hotplate Burner
3.1. To Replace the Ignition or Light Switch
2.6 To Change the Warmer Neon
2.2 To Replace the Hotplate Control Taps
3.2 To Replace the Clock
3.3 To Change the Warmer Switch
3.4 To Change the Ignition Generator
4.1 To Replace the Grill Controller
5.2 To Remove the Right-hand Oven Inner Back
5.1 To Replace a Thermostat
5.3 To Change the Fan in the Right-hand Oven
5.4 To Remove an Oven Element Thermal Cut-out
5.6 To Remove the Left-hand Oven Bottom and Top Elements
5.5 To Remove the Right-hand Oven Element
Bottom Element
Top Element
6.6 To Adjust an Oven Door Catch Keep
6.3 To Adjust an Oven Door Angle
6.2 To Replace an Oven Door
6.4 To Replace an Oven Door Outer Panel
Description
10. Circuit Diagram
Description
Colour
Maximum power output @ 230V 50 Hz
11. Technical Data
Usable volume litres
COUNTRY OF DESTINATION Australia
Tel +44 0 1926 457400 Fax +44
Clarence Street, Royal Leamington Spa Warwickshire, CV31 2AD, England
E-mail consumers@falconappliances.co.uk