JVC CA-UXH100 Specifications, Troubleshooting, English, Symptom, Possible Cause, Action, Tuner

6 Ω – 16 Ω

87.5 MHz—108.0 MHz

87.50 MHz—108.00 MHz

530 kHz—1 710 kHz

531 kHz—1 710 kHz

85 dB

85 dB Immeasurable

100 Hz—10 000 Hz

0.35 % (WRMS)

Troubleshooting

If you are having a problem with your unit, check this list for a possible solution before calling for service.

If you cannot solve the problem from the hints given here, or the unit has been physically damaged, call a qualified person, such as your dealer, for service.

Symptom		Possible Cause		Action
Power does not come on.	The power cord is not connected to an		Insert the plug into the socket.
	AC outlet.
No sound is heard.	•	Connections are incorrect or loose.	•	Check all connections and make
				corrections. (See pages 6 and 7.)
	•	A pair of headphones is connected.	•	Unplug the headphones from the
				PHONES jack.
	•	MP3 disc is recorded with “packet	•	It cannot be played. Replace the disc.
		writing.”

English

Hard to listen to broadcasts because of	•	Antennas are disconnected.
noise.
	•	The AM loop antenna is too close to
		the unit.
	•	The FM antenna is not properly
		extended and positioned.
The disc does not play.	The disc is upside down.
Specific files (tracks) on an MP3 disc are	Files other than MP3 are included in the
not played.	disc.
Impossible to record.	Small tabs on the back of the cassette are
	removed.

•Reconnect the antenna correctly and securely.

•Change the position and direction of the AM loop antenna.

•Extend FM antenna and orient to the best reception position.

Put the disc in with the label side up.

They cannot be played.

Cover the holes with adhesive tape.

Operations are disabled.	The built-in microprocessor has		Unplug the AC power cord then plug it
	malfunctioned due to external electrical		back in.
	interference.
Unable to operate the unit by the remote	•	The path between the remote control	•	Remove the obstruction.
control.		and the remote sensor on the unit is
		blocked.
	•	The batteries are exhausted.	•	Replace the batteries. (See page 6.)
	•	You are using the remote control too	•	Signals cannot reach the remote
		far from the unit.		sensor. Move closer to the unit.

Specifications Design and specifications are subject to change without notice.

Amplifier Section—CA-UXH100

Output Power:

10 W per channel, min. RMS, driven into 6 Ω at 1 kHz, with no more than 10% total harmonic distortion (IEC 268-3)

Speakers/Impedance:

Tuner

FM tuning range:

FM 100 kHz intervals:

FM 50 kHz intervals:

AM tuning range:

AM 10 kHz intervals:

AM 9 kHz intervals:

CD player

Dynamic range:

Signal-to-noise ratio:

Wow and flutter:

Cassette deck

Frequency response:

Normal (type I):

Wow and flutter:

General

Power requirement:	AC 110V–127V/220V–240 V ,
	adjustable with the voltage selector,
	50 Hz/60 Hz
Power consumption:	38 W (at operation)
	2 W (on standby)
Dimensions (W/H/D) (approx.):
	144 mm x 255 mm x 277 mm
Mass (approx.):	2.9 kg

Supplied accessories

See page 6.

Speaker Section—SP-UXH100

Type:	Full range Bass-reflex type
Speakers:	10 cm cone x1
Power handling capacity: 10 W
Impedance:	6 Ω
Frequency range:	100 Hz to 15 kHz
Dimensions (W/H/D) (approx.):
	130 mm x 257 mm x 151 mm
Mass (approx.):	1.5 kg each

22