JVC UX-H100, SP-UXH100, CA-UXH100 manual Selecting the Source

English

Basic and Common Operations (continued)

Selecting the Source

To select the source, press CD 6, TAPE, FM/AM, or AUX.

•When you select CD as the source, playback starts automatically.

To operate the tuner (FM or AM), see pages 10 and 11. To operate the CD player, see pages 12 to 14.

To operate the tape deck, see page 15. To record on a tape, see pages 17 and 18. To use an external equipment, see page 16.

Adjusting the Volume

You can adjust the volume level only while the unit is turned on. The volume level can be adjusted between “VOL MIN,” “VOL 01” – “VOL 30,” and “VOL MAX.”

•The volume level has no effect on recording.

To increase the volume, press VOLUME + (or	VOLUME
turn VOLUME control clockwise on the unit).
To decrease the volume, press VOLUME – (or
turn VOLUME control counterclockwise on the
unit).

•When you press and hold either button, you can change the volume level continuously.

For private listening

Connect a pair of headphones to the PHONES jack. No sound comes out of the speakers. Be sure to turn down the volume before connecting or putting on the headphones.

Selecting the Sound Modes

You can select one of the 4 sound modes.

•This function also affects the sound from headphones.

•This function only affects the playback sound, and does not affect your recording.

On the remote control ONLY:

To select the sound modes, press SOUND	SOUND
repeatedly.

•Each time you press the button, the sound mode changes as follows:

ROCK POP CLASSIC

OFF JAZZ

ROCK: Powerful sound emphasizing treble and bass.

POP: More presence in the vocals and midrange.

CLASSIC: Enriched sound with fine treble and ample bass.

JAZZ: Accented lower frequencies for jazz-type music.

OFF: Equalizer effect is canceled.

When the sound mode is activated, the SOUND indicator lights up on the display.

Adjusting the Tone (Bass/Treble)

You can adjust the bass level (low frequency range) and the treble level (high frequency range) within a range of –1 to +4. When shipped, the bass level set to “BASS 0” and the treble level set to “TREBLE 0.”

•This function only affects the playback sound, and does not affect your recording.

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start over from step 1.

On the remote control ONLY:

DO NOT turn off (standby) the unit with the volume set to an extremely high level; Otherwise, the sudden blast of sound can damage your hearing, speakers and/or headphones when you turn on the unit or start playing any source.

REMEMBER you cannot adjust the volume level while the unit is in standby mode.

Fade Muting

On the remote control ONLY:

Press FADE MUTING.	FADE
	MUTING

The volume level decreases to “VOL MIN,” and “MUTING” starts flashing on the display.

To release muting, press FADE MUTING again. The volume level resumes to the previous level.

•Adjusting the volume level also cancels the muting.

1 Press BASS/TREBLE once to adjust TREBLE
	BASS/
the bass level or press BASS/
TREBLE twice to adjust the treble
level.
2 Press PRESET UP to increase the	PRESET UP
level or press PRESET DOWN to
decrease it.
	PRESET DOWN

•You cannot use the tone adjustment function and the sound mode function at the same time. (The sound mode changes automatically into “OFF” when pressing BASS/TREBLE.)

•The bass/treble setting automatically returns to “0” when you select one of the sound modes (see “Selecting the Sound Modes” above).

9