JVC VN-V686UAPI manual Network Basics Enabling Network Setting Changes, Setting Dhcp for VN-V686

Example /api/param?camera.detection.area=000102030405060708090001

Example of response camera.detection.area&202 Accepted(camera.status=save)

Interpretation Change the motion detect mask. Specify using a 24 ASCII character string. Refer to the item on "Getting Motion Detect Mask from VN-V686" on the interpretation of this character string. To mask all blocks, specify all zeros in the ASCII character string. The change is saved by the API, camera.status=save. If the change is not saved, the setting is restored by reboot.

Allowed users admin, operator

6.10. Network Basics

The APIs below are related to the basics of networks. These are equivalent to the features on the Basic page of the WEB setting page. Refer to the instruction manual for details on the Basic page.

Enabling Network Setting Changes

Format /api/param?network.interface.status=restart

Example of Response network.interface.status&200 OK

Interpretation Changes of following network parameters become valid by this API. DHCP, IP Address, Subnet Mask, TTL, MTU, TOS, Negotiation

Changes are not reflected in the actions until this API is used. APIs to get settings of those parameters return previous values until this API is used. When this API is issued, VN-V686 reboots in about 1 minute.

Allowed user admin

Getting DHCP Setting from VN-V686

Format /api/param?network.interface.dhcp.status

Example of Response network.interface.dhcp.status=off&200 OK

Interpretation Acquire the current DHCP setting.

Allowed users admin, operator, user

Setting DHCP for VN-V686

Format /api/param?network.interface.dhcp.status=data

Example /api/param?network.interface.dhcp.status=on

Example of Response

network.interface.dhcp.status&202 Accepted(network.interface.status=restart)

Interpretation Change the DHCP setting. Specify "on" or "off". To validate the change, use "network.interface.status=restart" API that reboots VN-V686 in about 1 minute.

Allowed user admin

78