Kathrein CAP 700 manual Installation And Connection, Laying Cables And Connecting The Turntable

INSTALLATION AND CONNECTION

LAYING CABLES AND CONNECTING THE TURNTABLE

•Lay the coaxial cable to the UFS 740sw.

•Lay the turntable power supply cable (3-pin plug) to the battery.

Avoid laying the cables across sharp edges and protect the cables against possible chafing points.

•Connect the coaxial cable (coming from the turntable) to the “IF IN” F socket on the rear of the UFS 740sw.

•Place the infrared sensor for the receiver close to or directly on top of the TV set and lay the cable to the UFS 740sw. Connect the 6-pin Western connector at the rear to the socket marked “IR REMOTE IN”.

Note: Lay the AV cinch enclosed with the CAP 700 to the Scart cable. Take great care to plug the cables into the correct sockets! The cinch connector must be assigned to the UFS 740sw and the Scart connector to the TV set.

They must not be reversed - or the unit will not function!

CONNECTING TO THE UFS 740SW

Isolate the on-board power supply (master switch “off” or disconnect the positive pole of the on-board power supply battery) before commencing the following work:

•Connect the power cable supplied (depending on the power supply available in your motor home or

caravan, either a 12 V supply or a 230 V supply via a power supply unit) to the “” socket on the receiver.

Make sure that the “inline” integrated fuse (5 A) of the cable is fully plugged in and is intact. If the fuse blows, the source of the fault must first be eliminated. The fuse must only ever be replaced by a fuse with the same rating (5 A).

The fuses in the cable and in the receiver may never be bridged – cable fire hazard!

•At the connecting point for the power cable, the voltage must not fall below 10.9 V even with a load of 12 A. Otherwise optimum functioning can no longer be guaranteed.

•Connect the power cable to the respective socket in your motor home or caravan (12 V or 230 V).

21