GE ZIR36N RH Step Match handle extrusions to handle, Measure and mark 1/4″ below the top edge

Step 2

Match handle extrusions to handle

FOR CUSTOM

WOOD

PANELS

See Step 2A for Stainless Steel panels

ZKHRSS1 Trim Kit (For 1/4″ Panels)

Tubular Stainless Steel Handles

• Cut a piece of corrugated to use as a pad to

protect the panel finish. Use 1/2″ thick section
of plywood to protect flooring when drilling.
• Place custom panel on the pad, appearance side
down.	Back
• On the back side of the panel—at the handle side,	Side
	Custom
measure and mark 1/4″ below the top edge of the	Panel
panel with a pencil.

•Slip panel into new extrusion on the handle side of the panel.

•Align the extrusion at the pencil mark, 1/4″ below the top of the panel.

•Tape the extrusion to the panel to prevent movement.

•Center punch and drill 1/8″ pilot holes through the holes in the extrusion and into the panel.

•Turn panel over. On the appearance side, use 9/32″

bit to enlarge clearance hole.

IMPORTANT: Hole locations must be exact to accept
handle standoff and handle assembly.	Extrusion

Custom

Door

Panel

Step 2A

FOR

STAINLESS

STEEL

PANELS

If you are installing handle onto a Stainless Steel Panel:

Use extreme caution if you are drilling through a stainless steel panel. Stainless steel panels must be handled gently. Do not kneel on the stainless steel panel. It will leave a permanent dent. Do not remove protective plastic covering until final installation.

•Place supplied filler panel (corrugated) on floor to use as a pad.

•On the back side of the panel—at the handle side, measure and mark 1/4″ below the top edge of the panel.

•Slip panel into the new extrusion, flush against inner edge, on the handle side.

•Align extrusion to pencil mark as shown in Step 2. Mark each screw hole location with pencil.

•Tape extrusion to panel to prevent movement.

•Place panel on plywood section, appearance side down. Be sure plywood is clean without nicks and burrs. Center punch at each screw hole location.

•Drill 1/8″ pilot hole. Use 9/32″ bit to enlarge clearance hole.

•Measure and cut a 2″ wide strip, top to bottom off the corrugated panel. This will allow room for spacer rings between the stainless panel and extrusion.

30