GE ZIF36N RH ZUG75 Trim Kit, Unified 3/4″ Custom Grille Panel Kit, Step, Secure, Products

ZUG75 Trim Kit

Unified 3/4″ Custom Grille Panel Kit

Step 4	NOTE: This step can be used
Secure	as an alternative to Step 2,
Products	Anti-Tip bracket installation,
To Sides	whenever brackets cannot
	be used. Whenever possible,
	perform this step for additional
	anti-tip security.

When using 1/2″ to 3/4″ thick side panels, the front flange of the case trim is attached to the side panel.

•Open door to access case trim.

•Drill hole in trim slightly below the interior opening.

•Drive screw through the trim and into the side panel.

•Follow the same procedure on the opposite outside product trim.

	Refrigerator
Stud	Cabinet
	Door
	Spacer
	Block
OR

If the product is installed between cabinets with no side panels or into a custom enclosure, install a spacer block as shown.

Step 5	• Open doors fully.
Install Center	• Starting at the top, press trim strip over inside case
Trim Strip	trims of both products.
	• Continue pressing trim until you reach the bottom
	of the case trims. The trim will align with the top
	and bottom of the case trim.

Step 6

Remove Wire Fence and Switch Cover

Case Trim

U-Shape

Trim

Remove

3Screws

•Remove 3 screws holding the wire fence on both products. Retain fences and all screws.

Grill Base Cover

• Lift off grille base covers. Discard covers.

37