Mount assembled panel | GE ZIR36N LH, ZIF36N RH, ZIR36N RH, ZIF36N LH

ZKHTR1 Trim Kit (For 3/4″ Panels)

Support for Custom Handles

Step 4

Mount assembled panel

• Place assembled panel onto the bottom trim with support bracket tabs inserted into slots.

•Push the panel back against the steel door with handle extrusion flush to handle side of the door.

•Open door fully to stop.

•Install original screws at the top, hinge side and handle side.

28

Image 28

GE ZIR36N LH, ZIF36N RH, ZIR36N RH, ZIF36N LH installation instructions Mount assembled panel

Contents

Installation Instructions Contents ING Design Information 36″ Refrigerators, Freezers When Installed into a corner Side By Side Installation Freezer Refrigerator Installation Between Base Wall Cabinets Installation At End-of-RunAdvance planning exterior appearance options ″ thick custom panels-Without trim kits Models AvailableTrim kit Descriptions Custom Panel Dimensions Clearances ″ Panel Cut panels to size 35-1/16 Handles Custom Door Panel Dimensions Dimension a35 -1/16 Unified Custom Grille Panel 71-3/8 Thick Panel Custom Door Panel Dimensions Using Standard Trim Trim ″ Side Panels Insert end23 5/16 Installation Materials RequiredFlooring Grounding the Refrigerator Step Remove Packaging Install StepWater Line Shut off the main water supply Step Install Side Panels Illustration aIllustration B ″ to 3/4″ Side Panels Leading edge of side Level Or FreezerStep Secure To Sides Install 1/4″ Power StepDoor panels Check Adjust Door Temperature ControlsAlignment Arrange Interior Grille Panel Frame Adjustment ZGC2 Trim KitTo change grille panel size Pieces Parts List ZKHR1 Trim Kit For 1/4 ″ PanelsSupport for Custom Handles Tools and materials required Door using at least 2 screws Reinstall original screws into the door extrusionZKHR1 Trim Kit For 1/4″ Panels Locate handle position ZKTR36LH/ZKTR36RH Trim Kit ″ Custom Panels Install panels Back Side Custom Panel Install Handles Step AdjustGrille Panel height Top of the screws are 1/16″ from the surface Install four of the six larger undercut screws so thatGrille panel ZKHTR1 Trim Kit For 3/4″ Panels Tools and materials requiredPart List Before Temporarily mount door panel LocatePosition Assemble Mount assembled panel ZKHRSS1 Trim Kit For 1/4″ Panels Tubular Stainless Steel Handles If you are installing handle onto a Stainless Steel Panel Step Match handle extrusions to handleOn the back side of the panel-at the handle side Measure and mark 1/4″ below the top edge Step Install handles and panels Step Install standoffs onto handlesDecorator Raised Panel on 1/4″ Thick Backing ZKHTRSS1 For 3/4″ Panels KitBefore you Begin Using the Allen wrench provided. The standoff Match HandleTo Panel Should be tight against the handle ZUG75 Trim Kit Step Install Spacer PadsUnified 3/4″ Custom Grille Panel Kit Refrigerator and freezer must be secured to prevent tipping Roll Both Products into OpeningStep Level Both Products Step Remove Wire Fence and Switch Cover Install CenterTrim Strip Step Install Grille Base Cover Remove Grille Frame Unified Base Cover Step Install Soffit Vent Top Secure Custom Panel To Support Removing side screws. Discard top piece, retain Step Adjust Door Alignment